How can I fix this hood bend?
#1
Senior Member
Thread Starter
Join Date: Oct 2001
Location: reidsville,nc,usa
Posts: 504
Likes: 0
Received 1 Like
on
1 Post
Car: 1989 Firebird Formula 350
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: 9 Bolt Borg Warner 3.27 gears
How can I fix this hood bend?
I picked up my used hood today and the guy said it had 2 places on it. One dent will be fairly easy to do, no problem. The 2nd however is a little different. The front corner on the driver side is slightly bent down as if the car was hit up front on that side. The bend is not that bad... the pic was taken at a more slight angle that makes it look bad. What can I do? Rubber hammer and wood or body shop? At least its off the car and not painted yet.
Ken
Ken
Last edited by ken3983; 09-07-2008 at 05:48 PM.
#2
Member
Join Date: May 2006
Location: Lake Geneva
Posts: 103
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Camaro RS
Engine: 305 TBI
Transmission: TH350
Axle/Gears: Stock
Re: How can I fix this hood bend?
I would just bend it back up untill the lip is flat again, and if you have a kink, or dent there after that scuff it with 40-50 grit and put some filler on it.
In my build thread (link in my signature) my hood had a few nice dents on it at the front, I popped em out as much a possible and used tiger hair filler. I dont even think twice about it.
Just my 2 cents. I dont do bodyshops. I like to do everything myself.
In my build thread (link in my signature) my hood had a few nice dents on it at the front, I popped em out as much a possible and used tiger hair filler. I dont even think twice about it.
Just my 2 cents. I dont do bodyshops. I like to do everything myself.
#3
Supreme Member
iTrader: (11)
Join Date: Aug 2005
Location: Chicago(DP)
Posts: 1,170
Likes: 0
Received 0 Likes
on
0 Posts
Car: '90 RS
Engine: Vortec 350
Transmission: 700R4
Axle/Gears: 3.23 non posi
Re: How can I fix this hood bend?
Get it as close as you can to the contour it should be then if needed apply a thin layer of filler
#4
Member
Join Date: Jul 2007
Location: york, PA
Posts: 465
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 iroc camaro
Engine: jasper 350, l98
Transmission: 700R4, corvette servo, shift kit.
Axle/Gears: stock
Re: How can I fix this hood bend?
my hood was kind of warped when i got it. i actually instaled the hood and put pieces of wook on to of the fenders, shock tower, plenum, any where that i had to to push and pull the hood back to fairly straight.
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
12-10-2019 07:07 PM