89 GTA front plate
08-01-2023, 03:22 PM
#2
Member
Join Date: Dec 2021
Location: central Texas
Posts: 281
Received 106 Likes
on
75 Posts
Car: 91 TA Vert WS6-94 TA Vert
Engine: 5.0/5.7 LT1
Transmission: 700R4
Axle/Gears: 2.73-3.42
Re: 89 GTA front plate
If I were you, I'd leave it off. Pretty sure it requires drilling holes in the bumper. My State, (Texas,) requires a front plate, but I've decided to take my chances. Not going to F up my bumpers.
If I was forced to do it, I'd figure out a way to make this work:
If I was forced to do it, I'd figure out a way to make this work:
08-01-2023, 07:41 PM
#4
Supreme Member
Join Date: Apr 2017
Location: Northern NY
Posts: 1,116
Received 401 Likes
on
314 Posts
Car: 1988 Trans Am GTA
Engine: 5.7 L98
Transmission: 700r4
Axle/Gears: Borg Warner 9 bolt 3.27
Re: 89 GTA front plate
I have an original on my 88' GTA and wish it was without it as it has holes in the bumper, I too would take my chances and place it in the front windshield area. The front plat holder screws up the look IMO.
08-06-2023, 11:20 AM
#5
Supreme Member
iTrader: (11)
Join Date: Aug 2013
Location: MICHIGAN
Posts: 4,643
Received 754 Likes
on
580 Posts
Car: 1988 Trans Am
Engine: L03
Transmission: 700R4
Axle/Gears: 10 Bolt 2.73 Open
Re: 89 GTA front plate
I knew a guy once who would ran without it. He "lost" the original. He then applied for a "replacement" through the secretary of state, so he had that paperwork to show, if needed. Strangely, that darned replacement plate never did show up in the mail.
08-10-2023, 07:59 PM
#6
Supreme Member
iTrader: (5)
Join Date: Nov 2010
Location: Mantua NJ
Posts: 5,827
Received 64 Likes
on
57 Posts
Car: 1 Owner 1986 TA with a WS6 package
Engine: 5.0 EFI
Transmission: THM700R4
Axle/Gears: 277 Posi Speedo
Re: 89 GTA front plate
I have a NOS front plate holder and a used set of brackets if anyone is interested
The following users liked this post:
Roorancher (08-20-2023)
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post