Drum brake rubber line to steel braid swap
01-02-2015, 09:20 PM
#2
Supreme Member
iTrader: (14)
Join Date: Aug 2006
Location: Central NJ
Posts: 12,652
Likes: 0
Received 46 Likes
on
44 Posts
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: Drum brake rubber line to steel braid swap
Its just a clip, but its rusted to the bracket. You have to get a chisel and try to break it apart.
01-06-2015, 08:07 AM
#3
Banned
Thread Starter
Re: Drum brake rubber line to steel braid swap
That was the clip from hell. I finally got it off and I'm not sure exactly how. I had everything on the rear line loose except for that &^$#% clip and it was holding up the whole job. I think I blacked out a little in a psychotic rage but when I came to it was halfway off. It was a piece of cake after that.
Like I said, the fronts came off easily. The Russel steel braided lines went right on and the entire job front to back was simple, after that b%*&^ of a clip came off.
Like I said, the fronts came off easily. The Russel steel braided lines went right on and the entire job front to back was simple, after that b%*&^ of a clip came off.
Thread
Thread Starter
Forum
Replies
Last Post
AkDrifted
Engine/Drivetrain/Suspension Parts for Sale
6
08-17-2015 07:45 PM