Brake HELP!!!
#1
Member
Thread Starter
Join Date: Aug 2003
Location: Benton Ky.
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 Z28/86 T/A/98 R/A T/A
Engine: 355,355,LS1
Transmission: T-56,700r4,T-56
Axle/Gears: 3:73,3:42,3:42
Brake HELP!!!
So when I bought my 92Z it had been wrecked, and the rear end had been changed with an 85 disc rear, and never has had e-brake. I found the right rear after years of looking. I pulled it apart last night and its had lots of water in it, so it's junk. The brakes however are all there with e-brake cables.
My question is will the PBR aluminum calibers and rotors just bolt up to the 85 rear?
Can I change the mounting brackets and make them work?
Or, should I pull everything out of the 85 rear, which is all good stuff and 28 spline, and put it in the 92 housing to maintain the brakes??
Thanks in advance!!!
My question is will the PBR aluminum calibers and rotors just bolt up to the 85 rear?
Can I change the mounting brackets and make them work?
Or, should I pull everything out of the 85 rear, which is all good stuff and 28 spline, and put it in the 92 housing to maintain the brakes??
Thanks in advance!!!
#2
Moderator
iTrader: (5)
Re: Brake HELP!!!
https://www.thirdgen.org/forums/faq-...iscs-89-a.html
You'll find more info below, including info about master and combination valve:
https://www.thirdgen.org/forums/tran...-10-bolts.html
JamesC
Last edited by JamesC; 02-13-2015 at 11:51 AM. Reason: Further info
#3
Member
Thread Starter
Join Date: Aug 2003
Location: Benton Ky.
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 Z28/86 T/A/98 R/A T/A
Engine: 355,355,LS1
Transmission: T-56,700r4,T-56
Axle/Gears: 3:73,3:42,3:42
Re: Brake HELP!!!
FREAKIN AWESOME!!!! I LOVE THIS SITE!!!!
THANKS!!!!
THANKS!!!!
Thread
Thread Starter
Forum
Replies
Last Post
dbrochard
Engine/Drivetrain/Suspension Parts for Sale
6
09-19-2015 08:13 PM