Wiring fan to come on w/ign
#1
Member
Thread Starter
Join Date: Mar 2002
Location: North Carolina
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
Wiring fan to come on w/ign
Can someone please tell me how to wire my elec fan (88 305TBI) to come on as soon as I turn on the ignition? It would be much appreciated!!!!!:hail:
#2
Supreme Member
find ur fan relay. there should be a small green\w going into it. cut that and attach it to ground. thats it.. but the only control u have over it is from the ignition itself. i recomend a switch..
here is a diagram, urs is the same except it has only one fan..
here is a diagram, urs is the same except it has only one fan..
Last edited by breathment; 09-17-2002 at 08:01 PM.
#6
i pulled the pig tail off the sensor took a junk sensor and cut off the connector so i didnt have to butcher my new pig tail and used it to run a lead to a switch but if you ran it to ground it will come on as soon as the ignition is on. in my case i have it wired so both fans come on at once but even if i leave it off 1 fan comes on but only at about 240.
#7
Member
Thread Starter
Join Date: Mar 2002
Location: North Carolina
Posts: 177
Likes: 0
Received 0 Likes
on
0 Posts
Well I fixed it last night. I took the green wire w/white stripe and cut it and grounded it to the bracket that holds all the relays on the firewall and it works fine. Thanks guys.
Thread
Thread Starter
Forum
Replies
Last Post
eightsixseven
Tech / General Engine
1
08-14-2015 03:09 PM