DFI and ECM Discuss all aspects of DFI (Digital Fuel Injection), ECMs (Electronic Control Module), scanners, and diagnostic equipment. Fine tune your Third Gen computer system for top performance.

Blower causes engine to quit??

Thread Tools
 
Search this Thread
 
Old 08-11-2002, 09:06 PM
  #1  
Member

Thread Starter
 
RAD5's Avatar
 
Join Date: Apr 2000
Location: Orlando, FL USA
Posts: 312
Likes: 0
Received 1 Like on 1 Post
Car: 89 Formula 350
Engine: 5.7 TPI
Transmission: 700R4
Blower causes engine to quit??

Here is the deal …every time I turn on my A/C blower my tach jumps and the engine starts to run rough then quits. I have disconnected the air compressor thinking that was the problem but nothing changed. The alternator is new and I tested the charging system and the battery, both are fine. Sometimes I can turn on the blower and every thing is fine until I hit a bump then it goes nuts again. Once again the symptoms… when I turn on my A/C blower the tach jumps, speedometer jumps and service engine light flickers (it is on because of a code 36 that I have not fixed yet) I think I have a loose ground or power wire to the ECM but I do not know where they are. Any suggestions? Also when I turn on my wipes the same thing happens but not as bad.

89 Formula 350
350 TPI
Auto
No mods.
Old 08-11-2002, 09:45 PM
  #2  
Senior Member
 
hectorsn's Avatar
 
Join Date: May 2001
Location: Hollywood, FL
Posts: 502
Likes: 0
Received 0 Likes on 0 Posts
Car: 78 Regal
Engine: 82 FBod LG4 305, 730 ECM
Transmission: M20
Axle/Gears: 4.10
Yep, definitely a bad ground somewhere. Check for a good connection between the engine and firewall and the engine and the battery.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Frozer!!!
Camaros for Sale
35
01-19-2024 04:55 PM
masonta
TPI
13
08-31-2015 10:14 PM
NinjaNife
Tech / General Engine
27
08-23-2015 11:49 AM
mhatfield 14
Electronics
0
08-15-2015 10:47 AM
bradleydeanuhl
DFI and ECM
4
08-12-2015 11:48 AM



Quick Reply: Blower causes engine to quit??



All times are GMT -5. The time now is 01:38 PM.