Accel DFI Gen 7, Software and Cables needed
#1
Accel DFI Gen 7, Software and Cables needed
hey guys.
I am new here and saw a few of you have some accel DFI stuff in here. I am looking to buy some marine engines that are 597 Cu.in and whipple supercharged. The previous owner never ran them and has no idea if they been properly tuned. There is a full Accel DFI gen 7 kit on this thing.
My question is. Am I able to pull the existing Calibration file from it if i had the cables and software? My concern is having to scrap this system and start over.
Also would anyone here have the software, cables to communicate, and the USB Key for this unit.
I Dont want to be stuck with a boat anchor if i cant access the existing map incase it needs fine tuning.
Looking forward to your thoughts.
Steph
I am new here and saw a few of you have some accel DFI stuff in here. I am looking to buy some marine engines that are 597 Cu.in and whipple supercharged. The previous owner never ran them and has no idea if they been properly tuned. There is a full Accel DFI gen 7 kit on this thing.
My question is. Am I able to pull the existing Calibration file from it if i had the cables and software? My concern is having to scrap this system and start over.
Also would anyone here have the software, cables to communicate, and the USB Key for this unit.
I Dont want to be stuck with a boat anchor if i cant access the existing map incase it needs fine tuning.
Looking forward to your thoughts.
Steph
#2
Member
Join Date: May 2003
Location: San Jose
Posts: 103
Received 0 Likes
on
0 Posts
Car: 1990 IROC-Z
Engine: 355 TPIS Mini Ram, Vortech R-Trim
Transmission: 700r4
Axle/Gears: 3.73 Strange S60
Re: Accel DFI Gen 7, Software and Cables needed
Hi Steph
Yes, you will be able to pull the existing calibration once you have the cable. I suggest you join this group on Facebook "accel gen6 dfi gen 7 dfi support" the group can probably get you what you need. Also look up LANDIS PERFORMANCE on YouTube he has a couple of GEN 7 videos and might be able to get you the cable.
Memebr efiguy on here is another good source
Yes, you will be able to pull the existing calibration once you have the cable. I suggest you join this group on Facebook "accel gen6 dfi gen 7 dfi support" the group can probably get you what you need. Also look up LANDIS PERFORMANCE on YouTube he has a couple of GEN 7 videos and might be able to get you the cable.
Memebr efiguy on here is another good source
Thread
Thread Starter
Forum
Replies
Last Post