LO3, lt1 cam, fuel pressure?
07-22-2005, 04:36 AM
#1
Member
Thread Starter
Join Date: Jun 2004
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro RS
Engine: Stock 305 TBI
Transmission: Stock
LO3, lt1 cam, fuel pressure?
Hey, what did most of you TBI guys end up running your fuel pressure after an LT1 cam swap? I'm tryin to get a ballpark to set it at for my tuning. Thanks.
07-22-2005, 04:24 PM
#2
07-22-2005, 08:01 PM
#3
Senior Member
Join Date: Oct 1999
Posts: 6,621
Likes: 0
Received 1 Like
on
1 Post
Car: 91 Red Sled
Axle/Gears: 10bolt Richmond 3.73 Torsen
15 sounds fine. It'll run really rich at idle and part throttle open loop... even richer when in PE mode... unless you get cracking on the calibration.
07-23-2005, 11:29 AM
#4
Member
Thread Starter
Join Date: Jun 2004
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro RS
Engine: Stock 305 TBI
Transmission: Stock
Ok, i've got about 13.5 right now, think that will work, or should i try gettin a little more range out of my AFPR? I really need to get money for my chip burning stuff saved up, i'm new to it all and had carb plans but decided to not burn even more money doing that... So i just want a good baseline, one more thing i dont have to worry about screwing up when i start figuring this out.
Thread
Thread Starter
Forum
Replies
Last Post
R3500
Engine/Drivetrain/Suspension Wanted
1
08-17-2015 12:16 PM
92camaroJoe
Tech / General Engine
6
08-13-2015 06:07 AM
