Clear Codes 730
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Apr 2004
Location: Browns Town
Posts: 3,178
Likes: 0
Received 3 Likes
on
3 Posts
Car: 86 Monte SS (730,$8D,G3,AP,4K,S_V4)
Engine: 406 Hyd Roller 236/242
Transmission: 700R4 HomeBrew, 2.4K stall
Axle/Gears: 3:73 Posi, 7.5 Soon to break
Clear Codes 730
I have been playing with this in TP but have not had any luck.
To make this work I'm not sure of what the message length should be. The "56" was the value in an old file but don't believe it is correct. The other commands use the formula at the bottom.
I have the locations of the error words above.
Anybody figure this one out yet?
Code:
;-------------------------------------------------------------- ; SERIAL DATA RX MSG ; DEVICE ID = 0xF4, MODE 10 ; Reset Error Flags ; ; to make work (maybe ??) ; F4, 56, 0A 0004,0005,0006,0007,0008 + Cksum ; Device ID, length, Mode 10, "address" MSB, "Address" LSB, +Cksum ; ; (MSG LEN 2n+1+10+85 = 0xnn)
I have the locations of the error words above.
Anybody figure this one out yet?
Thread
Thread Starter
Forum
Replies
Last Post
BumpaD82
Tech / General Engine
37
02-26-2016 02:57 PM
gta892000
Cooling
6
09-16-2015 12:37 AM