Blade

Does anyone make a free editor for the ECMs in fox body mustangs ? A friend has an 88 GT and would like a custom chip done. I looked at the EPROM and it looks longer then ours, so it's probabably 30 pin. Anyone know how I could edit the resulting .bin if I read this EPROM ? Thanx

------------------
92 Z28 L98 350
---------------
Ported stock heads, XR270HR-10 cam, TES headers, Crane AFPR, Flowmaster catback, MSD ignition components.
Best ET 13.5@105 mph
"Take that auto, drop it in first, hold the brakes, stomp the gas and grin from ear to ear! :-)
Click here to see my car at Truspeed.org

Check out TruSpeed at http://www.truspeed.org
Check out the Bin Archive at http://www.truspeed.org/bins.html

MJT

I would also like to know. I have a Hypertech module that plugs into the service port of the ECM on my Mustang, since the EPROM's on EEC-IV's are integral. All the module does is interface with the I/O board by using a 28 pin EPROM. Stupid me, I forgot to look at the numbers on the EPROM while I had it out.