Help me sort out my mess with power locks
06-12-2006, 02:17 PM
#1
Member
Thread Starter
iTrader: (1)
Join Date: Feb 2005
Location: Rapid City, SD
Posts: 266
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Camaro RS/SS
Engine: LT1
Transmission: T-56
Axle/Gears: 10 bolt with 3.42
Help me sort out my mess with power locks
I have been trying to install an alarm on my Camaro and have messed up the power locks. The relay pack that the alarm came with is actually 2 relays with 5 wires coming out of it. I have cut up my existing harness at the factory relay connector, and when I connected the battery neither the locks worked, and the alarm relay pack got hot, and the driver's side switch melted. 
Help me figure out where these wires are supposed to go. I feel like the biggest idiot for cutting first.
Edit: Here's what is on the alarm relay pack
3 pin harness
- lock input
+ input for relay coils
- unlock input
5 wire harness
lock/unlock normally open #87
lock output #30
lock normally closed 87A
unlock output #30
unlock normally closed 87A
Help me figure out where these wires are supposed to go. I feel like the biggest idiot for cutting first.Edit: Here's what is on the alarm relay pack
3 pin harness
- lock input
+ input for relay coils
- unlock input
5 wire harness
lock/unlock normally open #87
lock output #30
lock normally closed 87A
unlock output #30
unlock normally closed 87A
Last edited by CamaroKid89RS; 06-12-2006 at 04:06 PM.
Thread
Thread Starter
Forum
Replies
Last Post
sailtexas186548
Problems / Help / Suggestions / Comments
2
08-24-2015 10:11 PM