H4 conversion question
#1
Member
Thread Starter
Join Date: Nov 2002
Location: Boise, ID
Posts: 382
Likes: 0
Received 0 Likes
on
0 Posts
Car: 90 Camaro RS
Engine: 6.3L 383 V8
Transmission: 700R4
H4 conversion question
I'm sure this has been asked a million times, but after hours of searching I can't seem to find anyone with the same problem. Here's the deal: I've installed actual HID low beams(ones with the ballast) and H4's in the high beams. When I switch to the High Beams, they are really dim and yellow. Its my understanding that they are not receiving enough wattage. I believe they are the 55/65w style. Are there relay kits to correct this? My low beams work perfectly BTW.
#2
Supreme Member
iTrader: (4)
Join Date: Mar 2009
Location: Pepperell, MA
Posts: 3,079
Likes: 0
Received 3 Likes
on
3 Posts
Car: 1987 Trans Am
Engine: LQ9/L92
Transmission: 4L60E
Re: H4 conversion question
take a look over at this thread to double check your wiring; you may just need to switch a couple of pins around:
https://www.thirdgen.org/forums/body...eadlights.html
https://www.thirdgen.org/forums/body...eadlights.html
#4
Junior Member
Join Date: May 2010
Location: St. Louis, MO
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 Pontiac Firebird
Engine: SMall Block 350 TBI
Transmission: 5-Speed
Axle/Gears: Stock(for now)
Re: H4 conversion question
Where did you get your HID kit from and do you have any links of the car with them installed?
Thread
Thread Starter
Forum
Replies
Last Post