Wiring
#1
Member
Thread Starter
iTrader: (3)
Join Date: Aug 2009
Location: WA
Posts: 350
Likes: 0
Received 1 Like
on
1 Post
Car: 1990 Camaro RS
Engine: LT1
Transmission: 4L60E
Axle/Gears: 10 bolt, 3.73 Ratio, Torsen LSD
Wiring
Quick question. Did 82-92 Camaros come from factory with a wire loom wire harnes? I was just wondering because nearly all of my wire harness is done in electrical tape, with just some of the ends using wire loom. Old electrical tape is nasty when you need to take it off, just makes a huge sticky mess.
#2
Banned
Join Date: Mar 2010
Location: In my garage next to my car
Posts: 474
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Red IROC
Engine: 5.7
Transmission: 700R4
Axle/Gears: 2.77
Re: Wiring
They would have the wires loosley taped (just enough tape to hold wires in a bundle)with loom around them.
#3
Member
Thread Starter
iTrader: (3)
Join Date: Aug 2009
Location: WA
Posts: 350
Likes: 0
Received 1 Like
on
1 Post
Car: 1990 Camaro RS
Engine: LT1
Transmission: 4L60E
Axle/Gears: 10 bolt, 3.73 Ratio, Torsen LSD
Re: Wiring
Thanks! Alright thats what I was wondering. Theres almost no wire loom and most the harness is completely taped so its likely somebodys mess. It just seemed like alot of work for somebody to do. it was done to wiring through the dash, from the ECM into the enginge bay, and even under the carpeting.
#4
Supreme Member
iTrader: (24)
Join Date: Jun 2005
Location: NC
Posts: 7,890
Likes: 0
Received 67 Likes
on
49 Posts
Car: 92 Firebird
Engine: Supercharged 6.0
Transmission: T56
Axle/Gears: 8.8 3.73
Re: Wiring
It was loomed with tape at the ends of the plastic to keep them together and every intersection. Very few runs were wrapped continuously with tape
Your 90 should be nearly all plastic split loom
Your 90 should be nearly all plastic split loom
Thread
Thread Starter
Forum
Replies
Last Post
Glowsock
Tech / General Engine
3
01-09-2017 04:06 PM