melted connector
05-18-2013, 02:43 PM
#1
Junior Member
Thread Starter
Join Date: Feb 2013
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Firebird
Engine: 3.1 L V6
Transmission: Automatic
melted connector
I have a 92 3.1 liter and i was looking under the hood and there is a connector that I don't know what it goes to, but it is melted some. It is near the Drier. Also if anyone can help me with ac problems that would be cool too. My cooling fan wont turn on and the clutch to the compressor won't spin either.
05-18-2013, 04:56 PM
#2
Re: melted connector
IIRC, when I was pulling my wiring apart, I though that connector was a little melty too, but it ended up just being old dialectric grease or something. I think that particular connector connects the HVAC controls to the rest of the engine harness.
05-20-2013, 04:23 PM
#4
Supreme Member
Join Date: Jan 2006
Location: Mooresville NC
Posts: 3,341
Likes: 0
Received 10 Likes
on
10 Posts
Car: LOWERED ♦ CRIMSON METALFLAKE
Engine: ► 400 KUBES ◄
Transmission: 765R4
Axle/Gears: EATON POSI 4.56
Lost His Cool
Originally Posted by Xphoidz
……My cooling fan wont turn on……
If it still won’t run the fan motor is defective.
If it does run remove the jumpers and make sure the fan is grounded.
If it is you have an open circuit from the hot in run circuit that was energizing the relay or the direct feed.
If it runs ground the fan switch in the engine.
If it runs the switch is bad.
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
I’ll Bump You Once To Move You Over, Next Time I’ll Spin You
Thread
Thread Starter
Forum
Replies
Last Post
TMZIrocZ350
Engine/Drivetrain/Suspension Parts for Sale
1
10-07-2015 12:09 PM
tmork454
Transmissions and Drivetrain
0
09-29-2015 06:33 PM
