TPi injector wiring...
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Oct 1999
Location: Derbyshire, United Kingdom
Posts: 796
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 camaro rs
Engine: 350
Transmission: T5
TPi injector wiring...
Hi all.
Im just completing a TPi conversion using a fueltech ECU on my 91 RS camaro in the UK.
But Im not sure which is the hot wire connection to the injectors. The pink/black one originally in TPi cars.
If I am looking at each injector from the side of the car (photo attached), which pin is the constant HOT feed? LH one or RH one?
Even my factory manual doesn't show me!
Thanks for any reply.
Andy.
Im just completing a TPi conversion using a fueltech ECU on my 91 RS camaro in the UK.
But Im not sure which is the hot wire connection to the injectors. The pink/black one originally in TPi cars.
If I am looking at each injector from the side of the car (photo attached), which pin is the constant HOT feed? LH one or RH one?
Even my factory manual doesn't show me!
Thanks for any reply.
Andy.
#2
Re: TPi injector wiring...
pink/black is the hot lead. injectors themselves are not polarized, but the connectors can only go on one way.
the ECM switches the ground on and off to fire them. hot side stays at a constant system voltage off the alternator.
the ECM switches the ground on and off to fire them. hot side stays at a constant system voltage off the alternator.
#3
Senior Member
Thread Starter
iTrader: (1)
Join Date: Oct 1999
Location: Derbyshire, United Kingdom
Posts: 796
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 camaro rs
Engine: 350
Transmission: T5
Re: TPi injector wiring...
Thank you for the reply.
So I can wire them up any which way I please??!!
I always find this quite weird. Going back to my school days Flemings LH and RH rule says otherwise! But you're the man!
Thank you.
Andy.
So I can wire them up any which way I please??!!
I always find this quite weird. Going back to my school days Flemings LH and RH rule says otherwise! But you're the man!
Thank you.
Andy.
#4
Supreme Member
iTrader: (11)
Join Date: Sep 1999
Location: NJ
Posts: 4,345
Received 298 Likes
on
234 Posts
Car: 92 Firebird
Engine: 4.8 LR4
Transmission: T56
Axle/Gears: 3.45 9 Bolt
Re: TPi injector wiring...
It doesn't matter which way. but I wire them all the same, whether I use terminal A or B, I keep it consistent for every injector
Thread
Thread Starter
Forum
Replies
Last Post
gta power
Tech / General Engine
8
08-08-2013 05:12 PM
ttypecamaro
DFI and ECM
2
08-14-2007 08:31 PM