Aluminum Heads
07-14-2006, 02:38 PM
#1
Member
Thread Starter
iTrader: (1)
Join Date: May 2004
Location: New Port Richey, Fl
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Trans Am
Engine: 6.6 at least
Transmission: T-56 (waiting)
Axle/Gears: 9" w/4.56 & spool (4 now)
Aluminum Heads
I have a set of bearly used Tri-thunder heads that I need to sell. These heads have less than 24 hrs of run time on them. Asking $800...payed $1000
specs: 190cc intake, 64cc chambers, 2.02in 1.60ex stainless swirl polished valves, guild plates, 3/8 screw in studs, angled plugs, Performance springs ( .550 lift). PC seals hardened locks,retainers and seats, manganese bronze intake guides, phosphor bronze exhaust guides. They are raised runner racing heads. If you have any ??? then send me a PM...
I will have pics up soon.....
specs: 190cc intake, 64cc chambers, 2.02in 1.60ex stainless swirl polished valves, guild plates, 3/8 screw in studs, angled plugs, Performance springs ( .550 lift). PC seals hardened locks,retainers and seats, manganese bronze intake guides, phosphor bronze exhaust guides. They are raised runner racing heads. If you have any ??? then send me a PM...
I will have pics up soon.....
07-19-2006, 10:35 PM
#4
Member
Thread Starter
iTrader: (1)
Join Date: May 2004
Location: New Port Richey, Fl
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Trans Am
Engine: 6.6 at least
Transmission: T-56 (waiting)
Axle/Gears: 9" w/4.56 & spool (4 now)
TTT
Last edited by brdofpry85ta; 08-22-2006 at 01:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post
ambainb
Camaros for Sale
11
04-25-2016 09:21 PM