85MikeTPI

iTrader: (2)

[ I sold and stored this motor for over a year, now it's for sale again. ]

I ran this 383 for 2 years while I was building my new motor. The 383 is documented here:
http://www.eecis.udel.edu/~davis/z28...18_383teardown

and I have Blackstone Oil samples over the life of the motor. The crank is a Eagle cast 400sbc ext balance, so the 153-tooth flexplate has the
400balance weight welded onto it. (would need to duplicate on a flywheel
if putting into a manual trans car)

Late model one piece seal, 2-bolt SBC 350 roller block prepped and 0.030 over
Eagle Cast Steel stroker crank (3.750 stroke)
Reconditioned 5.7" stock rods
KB Hypereutectic pistons (12cc dish)
LT4-HOT cam

Looking to get $700 for the motor/cam/balancer/flexplate (No heads)

Motor was running well when pulled, it was just time since the new motor was completed.

Have CompR lifters, HiTech push rods, and other misc parts if someone is looking for a more complete motor.

Contact for more details. Motor is located in Elkton, MD (21921) and I could probably deliver it within 50mi.

thanks
mike

jimlt4383

iTrader: (1)

whats your bottom dollor and how far south would you bring it? Its all together and ready for heads? did it use much oil? thanks , cash in hand.

crrllmich

Mike why didnt you tell me I might be interested!

rik89gta

whats up with the hot cam? is it a hydraulic flat tappet or a roller cam?

85MikeTPI

iTrader: (2)

383 has been loaned to a friend, who dropped a rod
in his motor. The 383 won't be available for sale until
the Spring now.. Sorry.

406man

Lesson learned?
Do not loan a motor to a friend.

Value just bottomed out on that motor.

Justin89Formy

iTrader: (26)

you dont build a stroker motor to grandma the car around town...sheesh

85MikeTPI

iTrader: (2)

Maybe you just need better friends...

kazer

I will take it this spring for $700 when it becomes available again. Think you could meet halfway to NC?