You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
ok i am selling my setup the only thing that needs to be done to the motor to get it done is drop the intake on and put the flex plate on and drop it into you car
please give me a call if u have any questions 219-331-5143 Thanks Eric
I am looking to get $4500 for it it includes the following
ENGINE
454 bored .060 over
KB pistons 12.0-1 compression
Eagle Rods forged
Scat Crank forged all Balanced
Comp cams http://compcams.com/Technical/Search...umber=11-220-4 629 629 lift cam
solid lifters
2 sets of roller rockers 1.7 and 1.8
stud girdles
arp head studs
arp main studs
high flow water pump
comp cam duel valve springs
Hardened keepers and retainers
Hooker headers super comp third gen swap bbc headers
Weiand team G intake
3 angle valve job
comp cams guide plates
ovel port heads ported
Proform 850cfm carb
sfi flex plate
sfi dampaner
solid motor mounts
----------
Last edited by transam360; 03-29-2008 at 03:59 PM.
Reason: Automerged Doublepost
i am going to school and i want to go a diffrent rout with the car so my loss is ur gain also the engine is ready to bolt in a third gen it even has the pan that clears the stock k member also has the 600 doller swap headers
