Lots of Performance Parts & Hood (Pelzer, SC)
#1
Member
Thread Starter
iTrader: (4)
Join Date: Mar 2004
Location: Honea Path, SC
Posts: 216
Received 15 Likes
on
11 Posts
Car: 1985 Z28
Engine: 383
Transmission: 700R4
Axle/Gears: 10 bolt/3.73
Lots of Performance Parts & Hood (Pelzer, SC)
I'm cleaning out the garage, and I've got several parts for sale right now. Because of the number of parts, I don't want to clog it up with a bunch of pictures, but PM/e-mail me if you want pictures.
Hedman PN 68466 1 5/8" longtube ceramic coated headers for small block Chevy in 82-92 Camaro/Firebird. Dent in passenger side header primary from using them with worn out stock engine mounts and a torque engine, but it shouldn't have a significant effect on performance. $150 [SOLD]
GM straight plug spark plug wires - $10
GM HEI for SBC - $50
Holley Shiny 600 cfm VS Carburetor. Originally electric choke but converted to manual choke. Good condition. $150 [SOLD]
Holley dichromate 600 cfm VS Carburetor. Manual choke and needs new needle and seat on one bowl from being adjusted too far down. $75
Summit chrome dual inlet fuel line with fuel pressure gauge and integrated filter. Brand new, installed on car and interfered with heater hose so replaced. $30
Two Dynomax 2 1/2" inlet/outlet Race Bullet mufflers. 12" body, 16" overall length. $35 ea [SOLD]
Dart Pro 1 (not Platinums) 215cc ported aluminum cylinder heads for SBC. 56-58cc combustion chambers (not positive of exact size) to increase compression ratio. 2.08/1.6 valves, 7/16" studs with guideplates. Comp 981 springs. $900
Edelbrock Performer RPM Air-Gap port-matched to 1206 Fel-Pro gasket for use with Dart heads also listed. For SBC $200
Comp Pro Magnum Roller Rockers for SBC 1.6 ratio for 7/16" studs. $250
Stock 15" x 7" Argent Gray Z28 5-spoke wheel. $50
Continental non-lockup 2400 rpm stall torque converter for 700R4. Drives like stock until you step on it. $250
Jeg's Lock-up 10" 3200 rpm stall torque converter for 700R4. $300
700R4 rebuilt to handle 450+ hp. I purchased this used from a TGO member and was not made aware that it has no lock-up and the tip of the input shaft is damaged slightly. It will fit with the Continental converter above but not the Jeg's one. Transmission drives and shifts great, but my car is used mostly on the street so I wanted the lock-up capability. If you're racing, this transmission and the Continental converter would make a good combo, or run it on the street with a tranny cooler. $500
Stock 85 Z28 hood. Does not include latch or hardware. Louvers are in good condition up top, but a couple of the pins are broken underneath so they are only retained at the front. $200
Edelbrock chrome, short, perimeter bolt valve covers with matching chrome Edelbrock breather for SBC. Slight rust. $20
If you would like to combine some of the parts into one purchase, I'd be willing to make a deal on them. All prices do not include shipping, and I will not ship the hood or transmission. I am located in Upstate SC in Pelzer.
Hedman PN 68466 1 5/8" longtube ceramic coated headers for small block Chevy in 82-92 Camaro/Firebird. Dent in passenger side header primary from using them with worn out stock engine mounts and a torque engine, but it shouldn't have a significant effect on performance. $150 [SOLD]
GM straight plug spark plug wires - $10
GM HEI for SBC - $50
Holley Shiny 600 cfm VS Carburetor. Originally electric choke but converted to manual choke. Good condition. $150 [SOLD]
Holley dichromate 600 cfm VS Carburetor. Manual choke and needs new needle and seat on one bowl from being adjusted too far down. $75
Summit chrome dual inlet fuel line with fuel pressure gauge and integrated filter. Brand new, installed on car and interfered with heater hose so replaced. $30
Two Dynomax 2 1/2" inlet/outlet Race Bullet mufflers. 12" body, 16" overall length. $35 ea [SOLD]
Dart Pro 1 (not Platinums) 215cc ported aluminum cylinder heads for SBC. 56-58cc combustion chambers (not positive of exact size) to increase compression ratio. 2.08/1.6 valves, 7/16" studs with guideplates. Comp 981 springs. $900
Edelbrock Performer RPM Air-Gap port-matched to 1206 Fel-Pro gasket for use with Dart heads also listed. For SBC $200
Comp Pro Magnum Roller Rockers for SBC 1.6 ratio for 7/16" studs. $250
Stock 15" x 7" Argent Gray Z28 5-spoke wheel. $50
Continental non-lockup 2400 rpm stall torque converter for 700R4. Drives like stock until you step on it. $250
Jeg's Lock-up 10" 3200 rpm stall torque converter for 700R4. $300
700R4 rebuilt to handle 450+ hp. I purchased this used from a TGO member and was not made aware that it has no lock-up and the tip of the input shaft is damaged slightly. It will fit with the Continental converter above but not the Jeg's one. Transmission drives and shifts great, but my car is used mostly on the street so I wanted the lock-up capability. If you're racing, this transmission and the Continental converter would make a good combo, or run it on the street with a tranny cooler. $500
Stock 85 Z28 hood. Does not include latch or hardware. Louvers are in good condition up top, but a couple of the pins are broken underneath so they are only retained at the front. $200
Edelbrock chrome, short, perimeter bolt valve covers with matching chrome Edelbrock breather for SBC. Slight rust. $20
If you would like to combine some of the parts into one purchase, I'd be willing to make a deal on them. All prices do not include shipping, and I will not ship the hood or transmission. I am located in Upstate SC in Pelzer.
Last edited by Clemson327; 05-19-2013 at 09:48 PM. Reason: Updated for sold items
#3
Member
iTrader: (2)
Join Date: May 2006
Location: Center Line, Michigan
Posts: 205
Received 0 Likes
on
0 Posts
Car: 88 Iroc
Engine: 383
Transmission: T56
Axle/Gears: 3.43
Re: Lots of Performance Parts & Hood (Pelzer, SC)
Pictures of headers and install pics please in case here my email jonturkiela@att.net
#4
Member
Thread Starter
iTrader: (4)
Join Date: Mar 2004
Location: Honea Path, SC
Posts: 216
Received 15 Likes
on
11 Posts
Car: 1985 Z28
Engine: 383
Transmission: 700R4
Axle/Gears: 10 bolt/3.73
Re: Lots of Performance Parts & Hood (Pelzer, SC)
Pictures of headers and install pics please in case here my email jonturkiela@att.net
#5
Member
iTrader: (7)
Join Date: Jan 2013
Location: Right here in front of you
Posts: 109
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Iroc T-top
Engine: 350 w/typical bolt-ons
Transmission: 5 speed
Axle/Gears: 3.42 zexel, TEN chromoly 28 splines
Re: Lots of Performance Parts & Hood (Pelzer, SC)
Pm regarding carbs
#6
Senior Member
iTrader: (5)
Join Date: Aug 2010
Location: Wichita Falls, TX
Posts: 916
Likes: 0
Received 8 Likes
on
8 Posts
Car: 91 Firebird,00 c2500,75 Vette
Engine: 3.1 but 350 soon, 350, 350
Transmission: T56 soon
Axle/Gears: stock 3.42 Posi to come
Re: Lots of Performance Parts & Hood (Pelzer, SC)
PM sent
#7
Member
iTrader: (8)
Join Date: Mar 2007
Location: Shreveport Louisianna Barksdale AFB
Posts: 342
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 Camaro
Engine: forged 383 11:1
Transmission: T56 TDP STAGE 2
Axle/Gears: 99 ws6 3.42 posi rear
Re: Lots of Performance Parts & Hood (Pelzer, SC)
if you still have the long tube headers email me at Jeremy.fazal@hotmail.com pics and your paypal info. Give me a GOOD price shipped and ill hit send on paypal
Trending Topics
#8
Senior Member
iTrader: (5)
Join Date: Aug 2010
Location: Wichita Falls, TX
Posts: 916
Likes: 0
Received 8 Likes
on
8 Posts
Car: 91 Firebird,00 c2500,75 Vette
Engine: 3.1 but 350 soon, 350, 350
Transmission: T56 soon
Axle/Gears: stock 3.42 Posi to come
Re: Lots of Performance Parts & Hood (Pelzer, SC)
Money has been sent for the headers. Thanks.
#9
Member
Thread Starter
iTrader: (4)
Join Date: Mar 2004
Location: Honea Path, SC
Posts: 216
Received 15 Likes
on
11 Posts
Car: 1985 Z28
Engine: 383
Transmission: 700R4
Axle/Gears: 10 bolt/3.73
Re: Lots of Performance Parts & Hood (Pelzer, SC)
Headers will be sent tomorrow, and list updated for sold items.
#10
Junior Member
Join Date: Jul 2008
Location: Somerset NJ
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM
Black89TA
Exterior Parts for Sale
9
07-23-2016 10:42 AM