Header collector donut gasket
02-04-2003, 11:55 AM
#1
Header collector donut gasket
I'm getting tired of replacing my driver's side header collector gasket once a month. I've been using standard 2.5" I.D. (actually 17/32") donuts. The problem is that they keep blowing out the
composite material between the steel windings. The y-pipe is lined up. The bolts are keeping enough pressure on it, but they continue to blow. I know someone makes a solid donut gasket, but the dummies at the parts store can't look anything up without a reference in the computer
Can someone tell me who makes them and where to get them. Part numbers would help the idiots behind the counter 
composite material between the steel windings. The y-pipe is lined up. The bolts are keeping enough pressure on it, but they continue to blow. I know someone makes a solid donut gasket, but the dummies at the parts store can't look anything up without a reference in the computer
Can someone tell me who makes them and where to get them. Part numbers would help the idiots behind the counter 
Thread
Thread Starter
Forum
Replies
Last Post
Breazlan
Engine/Drivetrain/Suspension Parts for Sale
1
09-25-2015 11:20 AM
Chad Speier
Engine/Drivetrain/Suspension Parts for Sale
3
09-24-2015 12:32 PM
