Stock cat diameter?
09-11-2005, 12:50 AM
#1
Junior Member
Thread Starter
Join Date: May 2005
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 IrocZ
Engine: 350
Transmission: 700r4
Stock cat diameter?
Hey guys,
I just purchased hedman shortie headers and the hedman ball flange y pipe which is 2.5 inlet and 2.5 outlet. I was wondering, what am i going to have to do to keep the stock cat. its wierd, because i have the stock cat on my car, but an aftermarket exhaust. Im not really even sure what diameter that is. but it is NO DOUBT way newer than say the y pipe is.
what do you guys suggest?
yes, my cat is gutted, so i'd rather just keep it and save money haha.
I just purchased hedman shortie headers and the hedman ball flange y pipe which is 2.5 inlet and 2.5 outlet. I was wondering, what am i going to have to do to keep the stock cat. its wierd, because i have the stock cat on my car, but an aftermarket exhaust. Im not really even sure what diameter that is. but it is NO DOUBT way newer than say the y pipe is.
what do you guys suggest?
yes, my cat is gutted, so i'd rather just keep it and save money haha.
09-12-2005, 11:09 AM
#2
Moderator
iTrader: (14)
Join Date: Mar 2000
Location: Littleton, CO USA
Posts: 43,169
Likes: 0
Received 35 Likes
on
34 Posts
Car: 82 Berlinetta/57 Bel Air
Engine: LS1/LQ4
Transmission: 4L60E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
If the 350 is the factory engine, then your cat inlet is 3".
If the 350 is not the factory engine, then we'd have to know what was.
If the 350 is not the factory engine, then we'd have to know what was.
Thread
Thread Starter
Forum
Replies
Last Post
toronto formula
Engine/Drivetrain/Suspension Parts for Sale
15
11-10-2015 06:17 AM
1988iroc350tpi
Tech / General Engine
8
08-14-2015 07:52 PM
