Cutout?
#1
Member
Thread Starter
Join Date: Jul 2007
Location: Lisle Illinois
Posts: 149
Likes: 0
Received 0 Likes
on
0 Posts
Car: 95 SHO. 87 IROC red 69 Vette blue
Engine: 3.0 Yamahammer.5.7 TPI L98, 350
Transmission: mtx4 ,700r4, 4speed,
Axle/Gears: 3.27, 3.73
Cutout?
Hi, so ive got hooker 2055's and a flowmaster catback and where the cat should be im going to put a cutout there, any tips or tricks to doing this, the hooker y pipe has a 3 inch outer diameter so a 3 inch inner diameter should fit over it and the flowmaster has a flange to bolt onto the cat (which a pipe would still have to go between the cutout and the catback) what else should i be looking into or looking for. anyone else done this? if you have some pics of your setup would be awesome.
#3
Member
Thread Starter
Join Date: Jul 2007
Location: Lisle Illinois
Posts: 149
Likes: 0
Received 0 Likes
on
0 Posts
Car: 95 SHO. 87 IROC red 69 Vette blue
Engine: 3.0 Yamahammer.5.7 TPI L98, 350
Transmission: mtx4 ,700r4, 4speed,
Axle/Gears: 3.27, 3.73
Re: Cutout?
I was going to leave it on there but I did not feel like cutting it off the old y pipe and fitting it onto the new one, so instead of just putting a pipe there I thought I would make it a bit more interesting and put a cutout there.
#4
Supreme Member
iTrader: (7)
Join Date: Jun 2008
Location: Minnesota
Posts: 1,468
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 IROC-Z
Engine: 370 LSX, LS3 Top End
Transmission: Built T-56
Axle/Gears: 9" Aluminum Center 3.89's
Re: Cutout?
I got the 2055s with a QTP 3" cutout right on the Y. I just had the cutout expanded to 3"i.d. to slip over the Y.
Pics in my sig link of how i made the cat bend work with the cut out.
Pics in my sig link of how i made the cat bend work with the cut out.
#5
Member
Thread Starter
Join Date: Jul 2007
Location: Lisle Illinois
Posts: 149
Likes: 0
Received 0 Likes
on
0 Posts
Car: 95 SHO. 87 IROC red 69 Vette blue
Engine: 3.0 Yamahammer.5.7 TPI L98, 350
Transmission: mtx4 ,700r4, 4speed,
Axle/Gears: 3.27, 3.73
Re: Cutout?
that looks very similar to what i was thinking of doing just with a flange on one end to bolt to the rest of the exhaust and the hanger by the cat
Thread
Thread Starter
Forum
Replies
Last Post