Cat converter hanger placment and orientation
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Jul 2009
Location: PA
Posts: 47
Likes: 0
Received 1 Like
on
1 Post
Car: 1986 Trans-Am
Engine: 305 4BBL
Transmission: THM 700 R4
Axle/Gears: 2.73 Stock
Cat converter hanger placment and orientation
This is a stupid question to even have to ask, but I need some help with the orientation of the catalytic converter hanger on an 86 trans am. I can't for the life of me figure out how this hanger goes back on the car.
If anyone has a picture of the original hanger placement and orientation I'd appreciate it.
Thanks in advance.
If anyone has a picture of the original hanger placement and orientation I'd appreciate it.
Thanks in advance.
#2
Senior Member
iTrader: (1)
Re: Cat converter hanger placment and orientation
This thread has a ton of good pictures that should help you out:
https://www.thirdgen.org/forums/exha...m-install.html
https://www.thirdgen.org/forums/exha...m-install.html
#3
Member
Re: Cat converter hanger placment and orientation
Bolts to the transmission,then 2 bolts into the rear of the converter bell flange,just did mine the other day but don't have a pic right handy.
Thread
Thread Starter
Forum
Replies
Last Post