8.5" rear end swap
#1
Junior Member
Thread Starter
Join Date: Dec 2011
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 Z28
Engine: 350ci
Transmission: Th350
Axle/Gears: 3.73
8.5" rear end swap
Im getting sick of the 7.5" rear end and I did a swap a 8.5 out of impala 95 rear end on my '82 truck and Im loving it and Im thinking of doing the same to my '92 Z28,my z28 has full suspension with aftermarket aluminum driveshaft and Im concerned about the length of the driveshaft after the swap because I dont want to cut/weld it did anyone here did this swap? I searched for topics and didnt find any
Last edited by 92-Z28; 06-26-2012 at 12:54 PM. Reason: Removed swear words
#2
Moderator
Join Date: Jul 1999
Location: 51°N 114°W, 3500'
Posts: 17,120
Likes: 0
Received 123 Likes
on
104 Posts
Car: 87 IROC L98
Engine: 588 Alcohol BBC
Transmission: Powerglide
Axle/Gears: Ford 9"/31 spline spool/4.86
Re: 8.5" rear end swap
Swapping into a truck with leaf springs is easy. Swapping any kind of non third/fourth gen diff into a third gen isn't quite so easy. The torque arm suspension doesn't easily swap over.
#3
Re: 8.5" rear end swap
I put a zr2 rearaxle in my 83z and had to shorten the drive shaft 1 1/4 inches. I built a custom 3 link so no torq arm issues for me. Check this forum under home brew road racer.
Last edited by AlkyIROC; 06-26-2012 at 10:26 PM.
Thread
Thread Starter
Forum
Replies
Last Post
hectre13
Engine/Drivetrain/Suspension Parts for Sale
2
12-11-2023 08:14 AM
hectre13
Engine/Drivetrain/Suspension Parts for Sale
7
08-26-2015 08:17 AM
1992 Trans Am
Engine/Drivetrain/Suspension Parts for Sale
1
08-08-2015 08:16 PM