[MD] 1990 Trans Am drag/bracket car with trailer
#1
Supreme Member
Thread Starter
iTrader: (3)
Join Date: Sep 2005
Location: MD
Posts: 1,685
Likes: 0
Received 3 Likes
on
3 Posts
Car: '88 IROC-Z medium orange metallic
Engine: L98
Transmission: 700R4
Axle/Gears: 3.27
1990 Trans Am drag/bracket car with trailer
1990 Firebird bracket car with open trailer for sale. Car runs regular 10.8x's @ 120+ on pump gas and has been some 10.60's in good air in the fall. 60's are 1.44-1.46. Just don't have the time or interest to race much anymore so I'd like to sell my car and trailer. Located in Maryland just south of Baltimore. Clean title in hand for car and trailer. The car is very streetable. Still has radio, power windows and locks, etc.
-Body: 1990 Firebird, T-Tops, no rust, painted 3 years ago, 8pt roll bar, subframe connectors, full interior, Harwood 3" cowl hood.
-Engine: SBC 385ci, Eagle crank, 5.7" h-beam rods, Mahle pistons, Total Seal rings, King XP bearings throughout, hyd roller, Comp 236/242*, double roller timing set with torrington bearing, AFR 195 heads fully ported, 11:1 compression, Milodon oil pan, Ported RPM Air Gap intake manifold, Custom built Holley carb w/QFT baseplate (flows actual 780cfm), 1.6 roller rockers, stud girdle, Hedman longtube headers, true dual exhaust with Magnaflow stainless mufflers, Powermaster mini starter and high output alternator,Powermaster mini starter, Powermaster high output alternator, Proform electric water pump.
- Transmission: TH400, Hughes 3500 converter, B&M Magnum Pro Grip shifter, large cooler plumbed with -6an lines.
- Rear: Strange 12 bolt, Eaton posi, 4.11 gears, also spare set of 3.73 gears included, custom steel driveshaft.
- Suspension: Spohn torque arm, Lakewood 90/10's front with trick springs, 50/50 in the rear with stock V6 springs, Spohn lower control arms with welded relocation brackets, subframe connectors.
- Fuel sys: Mallory comp 140 fuel pump, Aeromotive regulator, custom Holley double pumper carb with QFT baseplate, 4 corner idle, flows 780cfm, plumbed with all -AN lines.
- Misc: Brand new custom Cap5 Champion Billet wheels, 15x10 and 15x3.5" with brand new MT Pro Bracket radial tires on the rear and MT Sportsman front tires, ARC touch switch panel and relay board, deep cycle AGM battery relocated to the rear with cut-off switch and sealed box and properly wired.
Trailer also included, built in storage area with Craftsman tool box, shelves, 12V battery and winch. Trailer has good trailer tires (not car or truck tires), electric brakes, LED lights, 48" beavertail with sliding ramps.
$8500 for all.
-Body: 1990 Firebird, T-Tops, no rust, painted 3 years ago, 8pt roll bar, subframe connectors, full interior, Harwood 3" cowl hood.
-Engine: SBC 385ci, Eagle crank, 5.7" h-beam rods, Mahle pistons, Total Seal rings, King XP bearings throughout, hyd roller, Comp 236/242*, double roller timing set with torrington bearing, AFR 195 heads fully ported, 11:1 compression, Milodon oil pan, Ported RPM Air Gap intake manifold, Custom built Holley carb w/QFT baseplate (flows actual 780cfm), 1.6 roller rockers, stud girdle, Hedman longtube headers, true dual exhaust with Magnaflow stainless mufflers, Powermaster mini starter and high output alternator,Powermaster mini starter, Powermaster high output alternator, Proform electric water pump.
- Transmission: TH400, Hughes 3500 converter, B&M Magnum Pro Grip shifter, large cooler plumbed with -6an lines.
- Rear: Strange 12 bolt, Eaton posi, 4.11 gears, also spare set of 3.73 gears included, custom steel driveshaft.
- Suspension: Spohn torque arm, Lakewood 90/10's front with trick springs, 50/50 in the rear with stock V6 springs, Spohn lower control arms with welded relocation brackets, subframe connectors.
- Fuel sys: Mallory comp 140 fuel pump, Aeromotive regulator, custom Holley double pumper carb with QFT baseplate, 4 corner idle, flows 780cfm, plumbed with all -AN lines.
- Misc: Brand new custom Cap5 Champion Billet wheels, 15x10 and 15x3.5" with brand new MT Pro Bracket radial tires on the rear and MT Sportsman front tires, ARC touch switch panel and relay board, deep cycle AGM battery relocated to the rear with cut-off switch and sealed box and properly wired.
Trailer also included, built in storage area with Craftsman tool box, shelves, 12V battery and winch. Trailer has good trailer tires (not car or truck tires), electric brakes, LED lights, 48" beavertail with sliding ramps.
$8500 for all.
#2
Supreme Member
iTrader: (8)
Join Date: Oct 2001
Location: Il
Posts: 11,731
Received 782 Likes
on
527 Posts
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Re: 1990 Trans Am drag/bracket car with trailer
That looks like a smoking deal. If only you were closer.
Free bump
Free bump
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
Exterior Parts for Sale
5
04-04-2016 12:50 PM
3rdgenparts
Firebirds for Sale
0
08-06-2015 09:03 AM