Help, Window problems
#1
Junior Member
Thread Starter
Join Date: Jul 2007
Location: Indiana
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Car: '89 Chevy Camaro RS
Engine: 305 V8
Transmission: Automatic
Help, Window problems
The drivers door window on my '89 IROC comes up all the way but it is not going into the seal, it comes up just out side of the groove for it, which gives me wind noise and airflow. I have not taken the panel off of the door to look at it better, but I was just wondering if someone has fixed this problem before and if they had any tips. Thanks.
#3
Moderator
Re: Help, Window problems
Is it possible the weather stripping is shot? If not, you need to remove the door panel and adjust the window regulator up.
#4
Junior Member
Thread Starter
Join Date: Jul 2007
Location: Indiana
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Car: '89 Chevy Camaro RS
Engine: 305 V8
Transmission: Automatic
Re: Help, Window problems
I don't think it is the weather stripping, it seems like my window is loose. When I shut the door from outside and push on the window it shuts right, but when I try and roll it up from inside, I pull it in as long as I can and sometimes it will go in the weather stripping but most times it comes up half out of the weather stripping. Where do I need to post this so Gramps can reply?
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
05-10-2023 07:19 PM
1Aauto
Sponsored Vendors
0
08-26-2015 02:18 PM