Horn Question
12-24-2006, 09:19 PM
#1
Supreme Member
Thread Starter
Join Date: Sep 2005
Location: Osceola Indiana
Posts: 2,151
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 RS(sold) 1989 IROC-Z
Engine: 350 TPI
Transmission: 700R4
Axle/Gears: ones that turn
Horn Question
This sounds like a dumb question but im kinda stumped??? On my 89 the horn fell off, and it looks like it was held on with some kind of glue?? is this right or is there some other way that it should be attached? theres 3 little clips were the horn button ligns up with to hold it on and there some kind of hot glue looking material? should i try hot gluing it back on(not sure how it would move then?) or do they make stuff for this? any help we be greatly appreciated
in advance
in advance 
12-26-2006, 01:27 AM
#2
Supreme Member
Join Date: Feb 2004
Location: So Cal
Posts: 1,581
Likes: 0
Received 2 Likes
on
2 Posts
Car: 89 IROC Z28
Engine: 357 TPI
Transmission: 700R4
Axle/Gears: 3.42 Posi
I don't think it was glue on. I think it was plastic standoffs that went through the holes on the metal piece and then flatten by melting just the tips or it was maybe injected molded around the metal. Either way gluing it isn’t going to hold.
Here's what I did, I carefully drill a hole in the middle of the plastic stands and tap threads in them and used some epoxy on the thread of some screws and screwed the pieces back together. I hope I explained this clearly enough for you. It worked well for me.
Good Luck
Here's what I did, I carefully drill a hole in the middle of the plastic stands and tap threads in them and used some epoxy on the thread of some screws and screwed the pieces back together. I hope I explained this clearly enough for you. It worked well for me.
Good Luck
06-15-2007, 03:05 AM
#3
Member
Join Date: Jun 2007
Location: Rockford, IL
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
Car: 2000 SS
Engine: LS1
Transmission: a4
Axle/Gears: 3.42
Re: Horn Question
This sounds like a dumb question but im kinda stumped??? On my 89 the horn fell off, and it looks like it was held on with some kind of glue?? is this right or is there some other way that it should be attached? theres 3 little clips were the horn button ligns up with to hold it on and there some kind of hot glue looking material? should i try hot gluing it back on(not sure how it would move then?) or do they make stuff for this? any help we be greatly appreciated in advance
in advance
Thread
Thread Starter
Forum
Replies
Last Post