progress stage 1
02-26-2006, 04:36 PM
#1
Member
Thread Starter
iTrader: (1)
Join Date: Dec 2005
Location: lynchburg va
Posts: 201
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1990 chevy camaro rs
Engine: lt1
Transmission: 4l60e
Axle/Gears: 273:(
progress stage 1
installation of the lt1 begins at 10am. engine mounted and tranny bolted up all intact in the car by. 5. im exhausted.... now im looking to buy some headers. and i have a bunch of wiring to do. and need to drop the tank for the pump. whats the estimated work time on dropping/installing the tank?
02-26-2006, 05:01 PM
#2
Senior Member
iTrader: (2)
Join Date: Oct 1999
Location: Hattiesburg, MS, USA
Posts: 893
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Jade Green---Trans Am Converti
Engine: LS1
Transmission: T56
If it's your first time, estimate 3-4 hours to get the tank out and 8-10 to get the stupid thing back in. 
It's not too bad, just go ahead and take everything out. Remove the tires (at least the passenger) and get the rear as low as possible.
Kevin D.
It's not too bad, just go ahead and take everything out. Remove the tires (at least the passenger) and get the rear as low as possible.
Kevin D.
03-01-2006, 05:36 PM
#4
Junior Member
Join Date: May 2005
Location: tampa florida
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91 camaro
Engine: 305TBI
Transmission: 5 speed
When I changed my fuel pump I dropped the rear with only leaving the LCA's on. Makes it easier for for bolting up the rear after you get the pump installed. Just make sure you get car up high enough cause the fill tube on the tank gonna need some space.
Be safe and good luck!
Be safe and good luck!
Thread
Thread Starter
Forum
Replies
Last Post
Drone358
Transmissions and Drivetrain
4
12-10-2015 08:16 PM
david068513
Engine/Drivetrain/Suspension Parts for Sale
1
09-13-2015 11:24 AM