tunercat won't communicate
10-27-2012, 01:12 PM
#1
Member
Thread Starter
iTrader: (8)
Join Date: Jul 2007
Posts: 352
Likes: 0
Received 2 Likes
on
2 Posts
Car: 86 Camaro Z28
Engine: LT1 200cc Ai heads and cam
Transmission: T56
Axle/Gears: 4.10:1 Zexel Torsen
tunercat won't communicate
This is an 94 LT1 swap into an 86 camaro. Harness was made by Pocket. Just making sure I didn't miss anything.
I traced the continuity from the PCM to the ALDL, which is good. The ground is also good. I tried to jump A and B to see if it gave the finish code 12, did't get that either. Battery voltage is at 12V.
Edit: I just read that the 94-95 doesn't do flash codes
I traced the continuity from the PCM to the ALDL, which is good. The ground is also good. I tried to jump A and B to see if it gave the finish code 12, did't get that either. Battery voltage is at 12V.
Edit: I just read that the 94-95 doesn't do flash codes
Last edited by diablizzard; 10-27-2012 at 01:31 PM.
10-27-2012, 05:36 PM
#2
Member
Thread Starter
iTrader: (8)
Join Date: Jul 2007
Posts: 352
Likes: 0
Received 2 Likes
on
2 Posts
Car: 86 Camaro Z28
Engine: LT1 200cc Ai heads and cam
Transmission: T56
Axle/Gears: 4.10:1 Zexel Torsen
Re: tunercat won't communicate
I think I found it. I'm missing one of the power when key on pins. Now I just need to get a hold of one.
Thread
Thread Starter
Forum
Replies
Last Post
Linson
Auto Detailing and Appearance
12
10-01-2015 09:50 PM
