how much of a "shot" will 4AN handle?
#1
Senior Member
Thread Starter
how much of a "shot" will 4AN handle?
gents, i am running a dual stage, but am feeding both stages with one bottle through a 4AN line. I am running a TPI plate system from NOS.....with the regular/pee-wee solenoids....wet...also runing a single fogger nozzle drilled straight into the front of a K&N TB mounted air filter..also wet.....using another set of pee-wee 'noids. so, the noids will do 150 each....but I dont think the 4AN line supports that.....comments??
My set-up is jetted for 150/75 HP for a total of 225 on the 1st and 2nd stages right now....is it happening or not?
My set-up is jetted for 150/75 HP for a total of 225 on the 1st and 2nd stages right now....is it happening or not?
#3
Senior Member
Thread Starter
Re: how much of a "shot" will 4AN handle?
can you clarify as to why??
and specifically, can you answer the original question?
again, one is a plate on the TB the other is a nozzle in the filter.
1. how much will a 4AN line support.
2. I have seen 16 mph increases on the spray.....approx how much additional power do you think that is?
and specifically, can you answer the original question?
again, one is a plate on the TB the other is a nozzle in the filter.
1. how much will a 4AN line support.
2. I have seen 16 mph increases on the spray.....approx how much additional power do you think that is?
#4
Supreme Member
iTrader: (5)
Re: how much of a "shot" will 4AN handle?
fuel distribution issues for one. call the nitrous company and ask about how much of a shot it will support, I ALWAYS just put in a -6 nitrous line and forget about worrying about it. Those little solenoids aren't as reliable on bigger shots as for instance the NX brand larger solenoids.
#5
Member
iTrader: (2)
Join Date: Nov 2005
Location: Columbus
Posts: 353
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 Camaro rs.
Engine: 357 t88 turbo motor
Transmission: Powerglide
Axle/Gears: 3.55
Re: how much of a "shot" will 4AN handle?
250hp that dont mean your car wont make a little more pwer with a -6 at that point
Thread
Thread Starter
Forum
Replies
Last Post
roysatikas
Transmissions and Drivetrain
0
09-22-2015 08:15 PM