Looking for a tool
03-06-2002, 02:15 AM
#1
Senior Member
Thread Starter
Join Date: Jul 1999
Location: Brevard Florida
Posts: 686
Likes: 0
Received 0 Likes
on
0 Posts
Looking for a tool
There is a tool that I saw on someones web page the other day but I cant find it again.
It was a vice mounted tool that would put a bead near the end of a tube to keep intercooler tubing from comming apart.
Has anyone seen one of these, know what they are called or know where to get one?
It was a vice mounted tool that would put a bead near the end of a tube to keep intercooler tubing from comming apart.
Has anyone seen one of these, know what they are called or know where to get one?
03-06-2002, 06:06 PM
#2
Junior Member
Join Date: Jul 2001
Location: Florida
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
May want to try here:
http://www.powerhouseproducts.com/
http://www.powerhouseproducts.com/
03-08-2002, 11:36 AM
#4
Senior Member
Thread Starter
Join Date: Jul 1999
Location: Brevard Florida
Posts: 686
Likes: 0
Received 0 Likes
on
0 Posts
Found a picture of it:
The guy said its an inner diameter bead roller. Said he found it at a machinists supply house.
The guy said its an inner diameter bead roller. Said he found it at a machinists supply house.
Last edited by Dan W; 03-08-2002 at 11:42 AM.
03-14-2002, 11:22 PM
#5
Junior Member
Join Date: Jul 2000
Location: Toronto, Canada
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
I believe you are in need of a bead roller...
What you are looking for is a bead roller. You probably already knew that...
Anyways, there are a few available. Here are some links...
http://209.238.153.119/beadform.html -specifically for metal tubing, like you probably need. A little fancy
http://www.pro-tools.com/prospecial_rollstes.htm -another one for tubing. Simpler design...
...Mike
Anyways, there are a few available. Here are some links...
http://209.238.153.119/beadform.html -specifically for metal tubing, like you probably need. A little fancy
http://www.pro-tools.com/prospecial_rollstes.htm -another one for tubing. Simpler design...
...Mike
Last edited by GN_Mike; 03-14-2002 at 11:25 PM.
Thread
Thread Starter
Forum
Replies
Last Post
tyeo098
Tech / General Engine
38
11-30-2015 06:27 PM