Search: Posts Made By: DanzigEx
Showing results 1 to 22 of 22
Search took 0.03 seconds.
Forum: Electronics
04-12-2016, 02:19 AM
Replies: 19
Views: 5,373
Posted By DanzigEx

Re: Temp gauge pegs to min!

Assuming I'm correct lol
For now let's just focus on the temp gauge for now lol good enthusiasm though!

It's possible that the gauge is dying, perhaps the coil for the temp sender path is wearing...
Forum: Electronics
04-10-2016, 09:14 PM
Replies: 19
Views: 5,373
Posted By DanzigEx

Re: Temp gauge pegs to min!

First some info!
Info
Assuming your gauge looks like this. . . ...
Forum: Carburetors
01-25-2016, 05:39 PM
Replies: 3
Views: 828
Posted By DanzigEx

Re: Stalls when cold.

Hey Wildstar,
First do what SouthSide2 suggested, check to make sure you are getting power to the choke.
Once you are, set the choke cap to the 12'o clock mark as a starting point (we'll adjust...
Forum: Electronics
10-20-2015, 02:41 AM
Replies: 1
Views: 458
Posted By DanzigEx

Re: FM transmitter?

I honestly use this non-branded FM Transmitter. It works for while and if you need to use it longer just plug it in using a typical micro usb cable.

Unless you're looking for something fancier,...
Forum: Electronics
10-20-2015, 02:04 AM
Replies: 5
Views: 7,697
Posted By DanzigEx

Re: wire identification

Now I'm not to familiar with Tuned Port, however some quick searching of the distributors for your TPI came up with this:
...
Forum: Electronics
10-20-2015, 01:53 AM
Replies: 5
Views: 7,697
Posted By DanzigEx

Re: wire identification

MoJoe already gave you some good info on #2, so I'll help with #1.
I'm checking my manual, and the only pair of pink/black and black wires in the engine bay lead up to the Electronic Spark Control...
06-25-2015, 10:11 PM
Replies: 9
Views: 556
Posted By DanzigEx

Re: car stalled need help!

Spark, fuel, air.
Just throwing around ideas (so maybe someone else can chime in):
1. Check the plugs (you never know ha). I know I've accidentally put the spark plugs in the wrong order that...
01-27-2015, 07:53 PM
Replies: 17
Views: 4,769
Posted By DanzigEx

Re: Where to get IROC-Z font?

Found a font relatively close, just have to italicize it.
http://www.1001freefonts.com/evogria.font
If not, look up sans serif fonts.
Good luck
Forum: Fabrication
12-11-2014, 12:39 AM
Replies: 4
Views: 1,939
Posted By DanzigEx

Re: Idea for Center Console

Oi! Thanks for the input Tibo (https://www.thirdgen.org/forums/member.php?u=23367), that's a pretty sweet fab! I wasn't thinking about building from scratch, more along the lines of modifying...
Forum: Fabrication
12-10-2014, 01:15 AM
Replies: 4
Views: 1,939
Posted By DanzigEx

Idea for Center Console

Hey there, I was doodling around and I came up with a custom center console design. Now, I would try this myself, but I'm a broke a** college student (lol), with ZERO skills for fabrication.

Tell...
Forum: Interior
10-25-2014, 10:40 PM
Replies: 2
Views: 3,931
Posted By DanzigEx

Re: 86 Medium Gray interior color code?

Super, late and there seems to be policy about reviving old threads on the internet (lol), but luckily my RPO codes (in the console) were the original!

What I found for the interior trim and...
Forum: Electronics
10-12-2014, 07:50 PM
Replies: 3
Views: 1,610
Posted By DanzigEx

Re: HELP!!!!!!!!!!!!!!!!!!!!!!

Are you using the Stock Tachometer or an After-market tach? Does the tach stay low, read high, or some where in-between?

Going off of what Midias said, and considering our charging systems the...
Forum: Electronics
07-23-2014, 06:13 PM
Replies: 2
Views: 1,057
Posted By DanzigEx

Re: Fuel sending unit troubles

Hello! Sorry about reviving an old thread, but I noticed no one was able to help! I was curious if you still needed assistance with your gauge trouble/ found a solution?
Forum: Interior
07-14-2014, 07:07 PM
Replies: 5
Views: 845
Posted By DanzigEx

Re: Medium Dark Gray Color?

Looks like Silver/black rear to me, not to sure though.
Good Luck
Forum: Electronics
04-24-2014, 11:03 PM
Replies: 12
Views: 970
Posted By DanzigEx

A Possible Security Trick?

Hey folks, I'm new to TGO and loving the info and Third Gens on here!
Anyways, I was browsing the Industrial Electrical Section on Amazon, and noticed some Key Operated Switches! I was thinking,...
Forum: Electronics
04-24-2014, 10:44 PM
Replies: 2
Views: 715
Posted By DanzigEx

Re: fuel gauge not working properly

A 300 Ohm Resistor should put you just below 3 Volts, if your getting 5 volts. Although, I'd probably try to figure out why you're getting 5 volts first though! Good luck!
Forum: Electronics
04-24-2014, 10:31 PM
Replies: 20
Views: 862
Posted By DanzigEx

Re: name this part!

If you still have the old bulbs in your dash lights could of burnt out? Hopefully nothing worse though, here's hoping!
Forum: Fabrication
04-24-2014, 09:29 PM
Replies: 7
Views: 3,605
Posted By DanzigEx

Re: headlight swap

Hmm, looks sweet. Honestly it looks like they just removed the pop ups and hard mounted the lights (like on the Camaro). Then added a headlight cover, or some sort of protector. AT least that's the...
Forum: Carburetors
04-21-2014, 01:43 PM
Replies: 5
Views: 1,101
Posted By DanzigEx

Re: throttle cable help for 350 carb

Whoa bro! In the Applications area it says "Notes: Fits models with TPI only."
Don't, want you to spend +55 on a cable that won't fit XD
Good luck!
Forum: Body
12-02-2013, 09:26 PM
Replies: 17
Views: 1,109
Posted By DanzigEx

Re: any way to make these clear agian?

Hello! Just did a quick search and this looks promising:
http://www.instructables.com/id/How-to-polish-a-Lexan-windshield-for-under-4/?ALLSTEPS

Although, I'd also wait for a few more responses...
Forum: Electronics
11-08-2013, 09:08 PM
Replies: 3
Views: 1,031
Posted By DanzigEx

Re: fog lights turn off on high beams

The Fog lights do shut off when you turn on your high beams
It's pretty epic
03-18-2012, 12:33 PM
Replies: 4
Views: 1,262
Posted By DanzigEx

Re: 87 Iroc stalling out. Need a little advice.

Here's some suggestions: http://wiki.answers.com/Q/Why_would_a_car_run_in_park_but_stall_in_gear
Best I got so far.
Showing results 1 to 22 of 22


 
Forum Jump


All times are GMT -5. The time now is 05:17 AM.