Third Generation F-Body Message Boards

Search: Posts Made By: Dave87IROCZ
Showing results 1 to 41 of 41
Search took 0.09 seconds.
Forum: TPI
04-25-2007, 09:15 PM
Replies: 20
Views: 997
Posted By Dave87IROCZ

Re: Rough runnin tpi wtf ?????

You dont need the looking clips. The ford injectors are a little shorter than stock ones. You may want to grind down where the fuel rail mounts to the manifold. I put the ford 24s on and had them...
Forum: TPI
04-25-2007, 09:06 PM
Replies: 28
Views: 1,134
Posted By Dave87IROCZ

Re: What a blast!!!

I agree 100% Its all about 0-60. The torque is incredible. I tear up an ls1 off the line until about 80mph. Ive had my car for over 2 years and the acceleration still impresses me.
Forum: TPI
04-25-2007, 05:19 AM
Replies: 4
Views: 695
Posted By Dave87IROCZ

Re: who has the CAI secret???

I made a ram air setup for mine. Cost me about 20 bucks. Third gear is way better now. If you want to know more pm me. It was very easy took about 1 hour.
Forum: TPI
04-25-2007, 05:14 AM
Replies: 20
Views: 997
Posted By Dave87IROCZ

Re: Rough runnin tpi wtf ?????

Oxygen sensor. Is your fuel pressure steady or does it bounce? I doubt its the pickup coil. Possibly a tempeture sensor.
Forum: TPI
04-25-2007, 05:10 AM
Replies: 5
Views: 530
Posted By Dave87IROCZ

Re: Injector Swap

It should run ok without a tune, mine did. I got one through pcmforless. Check them out they are pretty cheap.
Forum: TPI
04-25-2007, 05:05 AM
Replies: 1
Views: 501
Posted By Dave87IROCZ

Re: hey would this fuel pump regulator work...

Dont buy the Holley one trust me. I used the bbk and holley and went back to stock. You dont need an adjustable one. Get a chip burnt and youll be fine. pcmforless is cheap and good. They recomend...
Forum: TPI
04-25-2007, 04:59 AM
Replies: 5
Views: 799
Posted By Dave87IROCZ

Re: roller rockers

I have been running the summit 1.6 aluminum ones for about a year. Its my daily driver and I beat the hell out of it. No problems for me. They also are pretty. Unless your hitting extremley high rpms...
Forum: TPI
04-22-2007, 10:05 PM
Replies: 3
Views: 410
Posted By Dave87IROCZ

Re: Where to get a stock fpr?

Thanks for the replys. I went to a junkyard snagged one of a 3.1 for 10 bucks. Running like new. They are the same. I tried the bbk and holley and they both suck. I sticking with stock. There was a...
Forum: TPI
04-22-2007, 11:35 AM
Replies: 3
Views: 410
Posted By Dave87IROCZ

Where to get a stock fpr?

I need the housing not just the diagphram. Anyone know besides a junk yard? Put a crap holley one on and its the second time the diagphrams leaking. I am so pissed right now. Worse I lent my buddy my...
Forum: TPI
04-22-2007, 11:30 AM
Replies: 4
Views: 555
Posted By Dave87IROCZ

Re: poping in the intake and radical idle please help

did you hook the vaccum line for the brake booster back up? I always forget. If you put a holley regulator on I suggest to take it off they are junk. I put one on and less than a year it was leaking....
Forum: TPI
04-14-2007, 05:50 PM
Replies: 1
Views: 467
Posted By Dave87IROCZ

Re: tpi 350 restart help

sounds like it could be the ignition module
Forum: TPI
03-27-2007, 11:54 PM
Replies: 10
Views: 641
Posted By Dave87IROCZ

Re: weird idle issues still

It sounds like the o2 to me.
Forum: TPI
03-27-2007, 09:08 PM
Replies: 10
Views: 641
Posted By Dave87IROCZ

Re: weird idle issues still

check your fuel pressure if its jumping your fuel pump is probably bad or the regulator. My car was doing the same thing. Your voltage will fluctuate because the alternator puts out more volts at...
Forum: Tech / General Engine
03-25-2007, 08:38 PM
Replies: 17
Views: 633
Posted By Dave87IROCZ

Re: shadey fuel pump replacement

Thats how I replaced mine. Cut a hole in the sheetmetal. Its right in the middle of the hump. It was so easy.
Forum: Tech / General Engine
03-25-2007, 06:04 PM
Replies: 1
Views: 361
Posted By Dave87IROCZ

Holley afpr problem. Question?

My junk holley afpr is leaking fuel through the vaccum line after 8 months. Can I use a stock diagphram with the holley unit?
Forum: TPI
03-25-2007, 05:20 PM
Replies: 10
Views: 560
Posted By Dave87IROCZ

Re: removing emission stuff for offroad racing. will it affect the computer.

I removed my air system with no problems. My ac was removed when I got the car. These things and the cat are all I would take off because nothing else is wort while.
Forum: TPI
03-25-2007, 05:15 PM
Replies: 3
Views: 526
Posted By Dave87IROCZ

Re: Rich problem and timing issue

You unplug the wire with the engine off. Base timing should be 6 advanced. Shut off the engine and plug it in. If your car is running rich its either a problem with the tune or something else like...
Forum: TPI
03-25-2007, 05:03 PM
Replies: 7
Views: 3,109
Posted By Dave87IROCZ

Re: TPS Adjustment steps question

You need to jump the wires from the tps. I just probe from the back of the conector with my dmm. A is black B is dark blue.
Forum: TPI
03-25-2007, 05:00 PM
Replies: 1
Views: 527
Posted By Dave87IROCZ

Holley afpr problem

I just checked my fuel pressure and when I pulled the vaccum line off the regulator fuel was squirting out. It stopped after a while though. I have been getting a check engine light on startup but...
Forum: TPI
03-18-2007, 04:20 PM
Replies: 2
Views: 562
Posted By Dave87IROCZ

My car was doing the throbbing crap. Check your...

My car was doing the throbbing crap. Check your fuel pressure and see if its steady. If not its either your fuel pump going bad or the pressure regulator. I just got a holley afpr and a granatelli...
Forum: TPI
03-18-2007, 04:12 PM
Replies: 11
Views: 889
Posted By Dave87IROCZ

I put the summit rockers on last winter. Its been...

I put the summit rockers on last winter. Its been a year and I beat the hell out of my car. All is well and I did notice a little more power. I had to get bigger valve covers though.
Forum: TPI
04-28-2006, 05:07 AM
Replies: 3
Views: 400
Posted By Dave87IROCZ

My car is doing it in 3rd. Its probably your...

My car is doing it in 3rd. Its probably your knock sensor. Check your timing. I find that when my car is cooler it dont do it but when it gets to 220 it does it big time. Im getting a custom chip and...
Forum: TPI
04-23-2006, 06:33 PM
Replies: 8
Views: 571
Posted By Dave87IROCZ

tps is supposed to be .54

tps is supposed to be .54
Forum: TPI
04-23-2006, 12:06 PM
Replies: 4
Views: 446
Posted By Dave87IROCZ

Yeah I definately will back the timing down when...

Yeah I definately will back the timing down when I get my chip. When I ran at 8 degrees it didnt really bog but was slower. My fastest times where all the way advance with alot of bogging. I know Ill...
Forum: TPI
04-23-2006, 06:31 AM
Replies: 4
Views: 446
Posted By Dave87IROCZ

I ran at route 66 yesterday

It was a fun day there were a few third gens there. I was able to make 8 passes. I just installed 24# ford racing injectors, 1.6 roller rockers, and a cloyes double roller billet steel timing set....
Forum: TPI
04-23-2006, 06:10 AM
Replies: 12
Views: 2,739
Posted By Dave87IROCZ

I had a Granatelli and loved it at first. Then in...

I had a Granatelli and loved it at first. Then in about 4 months car started running like crap and I was getting the maf code. I got a new one code went away but car still running like crap. I got a...
Forum: Aftermarket Product Review
04-22-2006, 08:24 PM
Replies: 54
Views: 3,574
Posted By Dave87IROCZ

I dont know why everyone bashes accel. The delco...

I dont know why everyone bashes accel. The delco modules kept burning on me so I got an accel and it works great. I also have an accel coil 5 years and my old u groove plugs were about 3 years old...
Forum: TPI
03-23-2006, 07:28 PM
Replies: 4
Views: 1,229
Posted By Dave87IROCZ

Tpi article in GM High Tech

I have been waiting for a follow up article for about 6 months and it finally has come out this month. Its called something old something new. This months is at the machine shop doing the heads and...
Forum: TPI
03-23-2006, 07:23 PM
Replies: 26
Views: 6,749
Posted By Dave87IROCZ

I was wondering the same thing about the fuel...

I was wondering the same thing about the fuel line because Im polishing the rails and painting the lines. I think there is a special tool needed to take it apart.
Forum: Tech / General Engine
03-20-2006, 08:31 AM
Replies: 2
Views: 396
Posted By Dave87IROCZ

thanks for quick reply. I was hoping I didnt have...

thanks for quick reply. I was hoping I didnt have to take it back off.
Forum: Tech / General Engine
03-20-2006, 08:03 AM
Replies: 2
Views: 396
Posted By Dave87IROCZ

Need help fast please

I installed a cloyes double roller timing set and I cant remember if the crank bolt goes on before the pulley. It looks like the pulley goes on first cause there is a lip on back that fits into the...
Forum: Electronics
07-05-2005, 03:57 PM
Replies: 4
Views: 628
Posted By Dave87IROCZ

Thanks for the info Vader. Looks like my best bet...

Thanks for the info Vader. Looks like my best bet is to wait till I get a scanner.
Forum: Electronics
07-04-2005, 10:25 AM
Replies: 4
Views: 628
Posted By Dave87IROCZ

Thanks for the reply. I just want to see if Im...

Thanks for the reply. I just want to see if Im getting any spark retard while driving. Can I run a jumper wire from the spark retard wire and tell that? I dont have a scanner and want to buy a few...
Forum: Electronics
07-04-2005, 06:35 AM
Replies: 4
Views: 628
Posted By Dave87IROCZ

How to test esc ?

Can someone tell me how to test the esc with a dvm ?
Forum: TPI
07-04-2005, 06:28 AM
Replies: 15
Views: 1,530
Posted By Dave87IROCZ

I have cam,rockers,headers,no...

I have cam,rockers,headers,no cat,flowmaster,hypercrap chip,siamesed runners,ported plenum,ported heads, adjustable afpr,transgo shift kit, k&n's, ram air, all accel ignition. When I installed the...
Forum: TPI
07-03-2005, 02:46 PM
Replies: 7
Views: 532
Posted By Dave87IROCZ

That is a pretty dumb design. Since Im gonna have...

That is a pretty dumb design. Since Im gonna have to take my plenum of again I think Im going to buy the Holley and return this one.
Forum: TPI
07-03-2005, 02:12 PM
Replies: 7
Views: 532
Posted By Dave87IROCZ

I put the bbk afpr on my car and my pressure...

I put the bbk afpr on my car and my pressure jumps at idle but when I give it gas it steadys I think its normal. I have a problem though the adjusting screw sits right against my plenun and its very...
Forum: TPI
07-03-2005, 01:09 PM
Replies: 27
Views: 6,492
Posted By Dave87IROCZ

Yeah talk about steep prices. I went to Murrays...

Yeah talk about steep prices. I went to Murrays and they wanted $480 for a stock one and $6oo for the Bosch.
Forum: TPI
07-03-2005, 01:04 PM
Replies: 15
Views: 1,530
Posted By Dave87IROCZ

I just got done tuning mine. Just a quarter turn...

I just got done tuning mine. Just a quarter turn of the screw makes a pretty big difference. I just used a dvm to my o2 sensor to adjust it. Its kinda hard doing that way because the voltage jumps...
Forum: TPI
07-03-2005, 08:00 AM
Replies: 15
Views: 1,530
Posted By Dave87IROCZ

I just installed one on my car and it idles...

I just installed one on my car and it idles better than ever. Ive noticed alot more power and throtle response. I havent even adjusted it yet and I have alot of mods done so Im sure Ill see even...
Forum: TPI
07-03-2005, 07:56 AM
Replies: 27
Views: 6,492
Posted By Dave87IROCZ

I just installed the Granatelli on my car after I...

I just installed the Granatelli on my car after I broke my old maf doing the tpis mod. Expensive mistake. My car idles better than ever and I noticed alot more power and better throtle response. I...
Showing results 1 to 41 of 41


 
Forum Jump


All times are GMT -5. The time now is 04:43 AM.