ZZ4 cam with vortec 350?
09-05-2002, 07:16 PM
#2
Supreme Member
iTrader: (5)
Join Date: May 2001
Location: Naples, FL
Posts: 1,055
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Firebird
Engine: 383 stroker
Transmission: T-56
I know that you'll have to scrap the stock springs to handle the lift of the ZZ4 cam. People stay the stock springs will only handle .450-.480, depending on who you talk to.
09-05-2002, 09:01 PM
#3
Supreme Member
You shouldn't have to much of a problem running a zz4 cam in a 350. JR305 is running a zz4 cam on a 305 with world heads with TBI. You will definetly need a chip tho.
09-05-2002, 09:33 PM
#4
Supreme Member
Join Date: Mar 2001
Location: CC, TX
Posts: 5,144
Likes: 0
Received 1 Like
on
1 Post
Car: 1999 Yamaha Banshee
Engine: 379cc twin cyl 2-stroke stroker
Transmission: 6 spd manual
Axle/Gears: 14/41 tooth
OH YEAH!
its a great cam, get your hands on one
seriously though i talked to a few people about the cam, these people had the cam in their car, they said it had some lope to it. i have never used it though. check sig.
its a great cam, get your hands on one
seriously though i talked to a few people about the cam, these people had the cam in their car, they said it had some lope to it. i have never used it though. check sig.
09-08-2002, 09:16 PM
#5
Senior Member
Join Date: Oct 1999
Posts: 6,621
Likes: 0
Received 1 Like
on
1 Post
Car: 91 Red Sled
Axle/Gears: 10bolt Richmond 3.73 Torsen
It is a decent roller cam for a mild motor and good heads. The zz4 cam in the base 330 motor would more than likely make MORE power than the zz4 crate motor just because of the heads. It'll lope but the lift is pretty high so don't expect it to be a super simple swap with the vortec heads.
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
08-20-2017 12:16 AM
