Anyone running an Edelbrock 3701?
08-06-2003, 09:43 PM
#1
Member
Thread Starter
Join Date: Aug 2002
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
Anyone running an Edelbrock 3701?
I recently picked up a modified 3701 manifold for my 92 TBI.
(The bolt holes have been altered so that they line up)
Is anyone else working with a similar setup ?
I'm looking for potential "gotchas" before I begin the install.
I still need to pick up gaskets, a new T-stat
(been putting that off for too long) and the 4bbl/TBI adapter
(The bolt holes have been altered so that they line up)
Is anyone else working with a similar setup ?
I'm looking for potential "gotchas" before I begin the install.
I still need to pick up gaskets, a new T-stat
(been putting that off for too long) and the 4bbl/TBI adapter
08-06-2003, 11:26 PM
#2
Supreme Member
iTrader: (2)
Join Date: Jan 2002
Location: Moorestown, NJ
Posts: 9,962
Likes: 0
Received 3 Likes
on
3 Posts
Car: 88 Camaro SC
Engine: SFI'd 350
Transmission: TKO 500
Axle/Gears: 9-bolt w/ 3.23's
heh... the intake i should have bought so i can still have heat and EGR. No, it should be a realatively straight forward install. My 2 in. tbi is set farther back over the intake where the q-jet secondaries would be so it doesnt pose a problem but if you use a low profile adapter taht centeres the tbi where it should be and you use a 454 tbi along with it, you may have clearence problems between the butterflies and the wall of the intake. Probably wont occure but its a problem with the performer rpm intake.
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
09-17-2020 08:26 AM
86IROC112
Engine/Drivetrain/Suspension Parts for Sale
4
08-17-2015 02:00 PM
