firedawg225

here are the 65pound injectors i bought from Advanced Auto. has anyone ever seen ones like these??

firedawg225

another

steve8586iroc

Do they have a brand name on them? Were they very expensive?

Steve

chevypower

That looks like the one injector that I had to replace from Autozone. It drips fuel and has a large fuel cone. I think its from the tip being up inside the injector, as where on the factory one its right at the end of the injector. The wide fuel cone really looks bad, some even misses the throttle bore. I'll be glad when I get the 388ci in with the 700cfm Holley 4bbl TBI unit installed. Most likely be another year though as I'm just now finshing up the short block. I figure at least $2500 to $3000 on the top side for a full roller setup inclucing Comp Cams shaft roller rockers. I definatly want to come close to 500Hp and about the same or a little more torque, even if I have to put a 100-125Hp shot of NO2 on it. But at least I taking my time and doing it right the first time. I feel my LO3 still has close to 100,000 miles left in it so I'm in no hurrey yet anyway.

camaronewbie

I bought Autozone injectors too - and they sucked - same dripping problem that was mentioned - I took 'em back, got my cash back. I got entire TBI unit at junkyard for $45 - those injectors were nasty looking, but cleaned up and worked fine.

firedawg225

how do you guys clean your injectors??