TBI Throttle Body Injection discussion and questions. L03/CFI tech and other performance enhancements.

Everything ignition new, getting fuel, still low idle and stalling

Thread Tools
 
Search this Thread
 
Old 08-06-2005, 09:36 PM
  #1  
Senior Member
Thread Starter
iTrader: (1)
 
mult68's Avatar
 
Join Date: Oct 1999
Location: Carrollton, TX, USA
Posts: 779
Likes: 0
Received 0 Likes on 0 Posts
Car: 1992 Chevy Camaro RS
Engine: 305 TBI
Transmission: T-56
Everything ignition new, getting fuel, still low idle and stalling

I just replaced the distributor, pickup coil, ignition module, and ignition coil. Plugs and wires are new.

To put the distributor in...I had someone crank the engine while my finger was on the #1 plug hole. When I felt a big puff of air I put the distributor in with the rotor facing that way. Hooked everything up and double checked the firing order. Was this ok?

I started her up....she was a little hesistant and then she started up fine. She will idle well for a couple of seconds and then the idle will drop and the car will die unless I give it some gas. As long as I'm giving the car gas it stays running. I also tried putting it in first with the clutch in, and it did the same thing. She is running a LITTLE smoother than before (before I changed everything) but not good enough obviously.

I still need to change the fuel filter (its old) and get the timing dead on. Is it possible that I put the distributor in wrong? Any other ideas?

Also, to give some history, she sat for a long time while I slowly put the T56 in. While I did that, I also took out the AIR system and put in a smog delete pump.....hope this doesnt have anything to do with it. For the cat, I kept the stock one on for now, and just clamped the AIR pipe down and put some JBWeld over it.

Any ideas? I really need to get this car on the road soon. Thanks a lot
Old 08-07-2005, 01:21 AM
  #2  
Supreme Member

iTrader: (3)
 
Ramair21's Avatar
 
Join Date: May 2004
Location: stockton, CA
Posts: 2,233
Likes: 0
Received 4 Likes on 4 Posts
Car: Camaro RS/SS
Engine: 5.7 LS1
Transmission: 4L60E Transgo shift kit, 3500 stall
Axle/Gears: 4th Gen Rear 3:42
sounds like you lack fuel. Change out your gas filter and see how it acks.
Old 08-07-2005, 02:37 AM
  #3  
Supreme Member

iTrader: (1)
 
BronYrAur's Avatar
 
Join Date: Jun 2002
Location: Chicago, IL
Posts: 1,843
Likes: 0
Received 2 Likes on 2 Posts
Car: 91 Camaro RS Convertible
Engine: 305 TBI
Transmission: 5-Speed
Axle/Gears: 3.42
Did you set your timing with a timing light? What is it set at now?
Old 08-07-2005, 05:41 AM
  #4  
Junior Member
 
nameinuse's Avatar
 
Join Date: Aug 2005
Posts: 61
Likes: 0
Received 0 Likes on 0 Posts
Do you have an EGR valve?If so ,check that the pintle closes properly and the gasket for leaks.
Old 08-07-2005, 07:37 PM
  #5  
Supporter/Moderator

iTrader: (7)
 
ShiftyCapone's Avatar
 
Join Date: Feb 2001
Location: Cincinnati, OH
Posts: 13,247
Likes: 0
Received 392 Likes on 299 Posts
Car: '90 RS
Engine: 377 LSX
Transmission: Magnum T56
As Bron mentioned you need to set your timing. Your timing is off even though you got it in the general area of TDC. A few seconds with a timing light and a distributor wrench should turn things back to normal.
Old 08-07-2005, 11:46 PM
  #6  
Supreme Member

iTrader: (3)
 
Ramair21's Avatar
 
Join Date: May 2004
Location: stockton, CA
Posts: 2,233
Likes: 0
Received 4 Likes on 4 Posts
Car: Camaro RS/SS
Engine: 5.7 LS1
Transmission: 4L60E Transgo shift kit, 3500 stall
Axle/Gears: 4th Gen Rear 3:42
Yeah the sounds right too about the timing, but i think he should change his fuel filter still. He said it was old.
Old 08-09-2005, 07:25 AM
  #7  
Senior Member
Thread Starter
iTrader: (1)
 
mult68's Avatar
 
Join Date: Oct 1999
Location: Carrollton, TX, USA
Posts: 779
Likes: 0
Received 0 Likes on 0 Posts
Car: 1992 Chevy Camaro RS
Engine: 305 TBI
Transmission: T-56
alright hopefully i can set the timing tonight after work...but question...since I cant keep the car idling without it dying....I can go ahead and have someone stepping on the gas to keep it running while I set the timing right?
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
9192camaro
Engine/Drivetrain/Suspension Parts for Sale
16
02-03-2019 12:21 AM
jklein337
Tech / General Engine
2
09-19-2018 06:23 PM
Infested
Tech / General Engine
3
05-22-2018 11:56 PM
92camaroJoe
Tech / General Engine
6
08-13-2015 06:07 AM



Quick Reply: Everything ignition new, getting fuel, still low idle and stalling



All times are GMT -5. The time now is 02:51 AM.