Just a few tune up questions
09-23-2008, 02:50 PM
#1
Member
Thread Starter
Join Date: Nov 2006
Posts: 285
Received 0 Likes
on
0 Posts
Car: 1991 Camaro RS
Engine: LO3
Transmission: T-5
Just a few tune up questions
The car is a 1991 RS LO3 with about 200k miles, I have no idea what plug wires to run, and I have ran a search, but no results really. Help me make sure I am picking the right parts before I waist my money please 
ACDelco cheap plugs.
ACDelco Cheap rotor
MSD Dis Cap, cheapest available?
Then I was going to run some High Millage oil, What weight and brand does everyone like the best? Does the type of oil filter make any difference at all?
I dont want to cut cost and risk my engine or fuel millage, but I dont want to spend more than I have to either.
ACDelco cheap plugs.
ACDelco Cheap rotor
MSD Dis Cap, cheapest available?
Then I was going to run some High Millage oil, What weight and brand does everyone like the best? Does the type of oil filter make any difference at all?
I dont want to cut cost and risk my engine or fuel millage, but I dont want to spend more than I have to either.
09-23-2008, 08:03 PM
#3
Senior Member
iTrader: (2)
Join Date: Dec 2007
Location: Virginia
Posts: 990
Likes: 0
Received 5 Likes
on
5 Posts
Car: 1992 Firebird
Engine: 350TBI
Transmission: 700r4
Axle/Gears: Ford 9in 4.10
Re: Just a few tune up questions
Regular AC Delco plugs are the best for stockish cars.
If it leaks oil, go with higher weight [10w40, 10 or 20w50 if it leaks a lot] other then that just get synthetic 10w30
Use a good oil filter [Mobil 1]
For the wires just go to the parts store they will tell you what you need. Basically just regular old wires, nothing special needed for our cars.
If youre doing full ignition tune, go ahead and get an MSD or Accel Coil too.
I think its Jegs? I saw an MSD cap/rotor for like 24$ I think, Save you like 50cents and gets you all MSD, lol.
Might want to try so seafoam mixed in with your gas and some sucked in through the vaccum hoses also, I did it and it helped smooth my car out a little bit. But dont put it in your oil or it might leak more/start leaking.
If it leaks oil, go with higher weight [10w40, 10 or 20w50 if it leaks a lot] other then that just get synthetic 10w30
Use a good oil filter [Mobil 1]
For the wires just go to the parts store they will tell you what you need. Basically just regular old wires, nothing special needed for our cars.
If youre doing full ignition tune, go ahead and get an MSD or Accel Coil too.
I think its Jegs? I saw an MSD cap/rotor for like 24$ I think, Save you like 50cents and gets you all MSD, lol.
Might want to try so seafoam mixed in with your gas and some sucked in through the vaccum hoses also, I did it and it helped smooth my car out a little bit. But dont put it in your oil or it might leak more/start leaking.
Thread
Thread Starter
Forum
Replies
Last Post
