TBI with 4 Barrel Seals
#1
Junior Member
Thread Starter
Join Date: Jan 2009
Location: Havelock, NC
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Chevy Camaro
Engine: V8 305
TBI with 4 Barrel Seals
I just purchased 2 fel-pro intake sets ms90314-2 and ms93317. the ms90314 is for a 4 barrel set-up. i have tbi and use the 93317, will the front and rear intake seals in the 4 barrel set-up work for my 305 tbi block set-up. i dont want to use only the black rtv to seal up the front and rear. but that is what my set-up calls for. i would not mind using the gaskets and a little bit of rtv on the gaskets if they will work. any advice would be helpful.
#2
Member
Join Date: Jul 2007
Location: Lake Jackson Tx
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91z,97ws6,98fb,87&90jeep,05 yz250
Engine: 5.0tpi,5.7LT4,5.7LS1,4.2I6,5.7TPI,1
Transmission: t5,4l60e,
Axle/Gears: 3.42
Re: TBI with 4 Barrel Seals
i never use the seals and only use blk rtv for the front and rear as well as a little around the h2o ports on both sides of the gasket and a small stream from the h2o ports to the front and rear. Just let it set up for a bit to get tacky before putting the intake on. Then once bolted on i go back and wipe up the excess rtv for a clean look
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
12-10-2019 07:07 PM
1Aauto
Sponsored Vendors
1
01-15-2016 06:26 AM