TBI conversion. no start
#1
Junior Member
Thread Starter
Join Date: Dec 2006
Location: Port Orchard, WA
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1983 Z-28
Engine: 454
Transmission: TH700R4
Axle/Gears: 7.5" with 3.23 gears
TBI conversion. no start
I have kind of an interesting issue with my Camaro.I recently put a 454 in it and then decided to put the TBI system from the donor truck in it. The problem I am having is it will not start without adding fuel down the throttle body. after it starts it runs ok.I am pretty sure that the injectors don't fire while cranking. Now according to the wiring diagram that I have the I the "injector A" fuse is only powered with key on. Could it be that the "injector" fuse is suppose to be hot while in run and start? Or is there some other possibility.
#2
Moderator
iTrader: (1)
Join Date: Mar 2002
Location: Chasing Electrons
Posts: 18,408
Likes: 0
Received 217 Likes
on
203 Posts
Car: check
Engine: check
Transmission: check
Re: TBI conversion. no start
Yes, hot in both run & crank. You likely wired it to an accessory feed, which is cold during cranking.
RBob.
RBob.
#3
Junior Member
Thread Starter
Join Date: Dec 2006
Location: Port Orchard, WA
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1983 Z-28
Engine: 454
Transmission: TH700R4
Axle/Gears: 7.5" with 3.23 gears
Re: TBI conversion. no start
Thanks. i shall fix that after I drink coffee.
Edit: Fixed! Starts right up and runs good. now route the wiring and secure it. then get it ready for racing
Edit: Fixed! Starts right up and runs good. now route the wiring and secure it. then get it ready for racing
Last edited by davesengineshop; 01-01-2013 at 12:26 PM.
Thread
Thread Starter
Forum
Replies
Last Post
92camaroJoe
Tech / General Engine
6
08-13-2015 06:07 AM