Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!

hot start

Thread Tools
 
Search this Thread
 
Old 10-18-2001, 10:16 PM
  #1  
Junior Member
Thread Starter
 
silver89Rs's Avatar
 
Join Date: Jul 2001
Location: westland mi
Posts: 82
Likes: 0
Received 0 Likes on 0 Posts
hot start

i searched the archives to find info on ts common problem, but no one says how to fix it. so could someone tell me what to do to fix this hot start problem

------------------
89 Rs camaro
305 tbi
3in flowmaster muffler
manderal bent pipe
no cat

ELECTRONICS

viper alarm
pioneer 4-way 6x9's
15' orion sub in a bandpass box
150x1 kenwood amp
140watt aiwa head unit
Old 10-18-2001, 10:18 PM
  #2  
Moderator

 
IROCThe5.7L's Avatar
 
Join Date: Jul 2001
Location: Buffalo, NY
Posts: 5,193
Received 58 Likes on 39 Posts
Car: 1988 IROC-Z
Engine: 427 SBC
Transmission: ProBuilt 700R4
Axle/Gears: Moser 12 Bolt / 3.73 TrueTrac
If it makes you feel better, I have that problem too

Cold Start = Vrooooom

Hot start = Takes 2-3 turns of the key to start her up.

------------------
1988 Jet Black IROC
5.7L W/ 64000 miles
Flowmaster Exhaust
Fully Loaded
------------------

My IROC In Readers Rides
My IROC
Old 10-18-2001, 11:52 PM
  #3  
Supreme Member
 
breathment's Avatar
 
Join Date: Jun 2001
Location: Bedford, Tx
Posts: 3,175
Likes: 0
Received 1 Like on 1 Post
i think it has something to do with the fact that during most cold starts, we have extra fuel being added, cause the engine is cold, 87+ (?) cars have the cold start injector, while 89+ have main injector enrichment, so this is why I think cold starts are better then warm starts. also, might wanna try replacing Coolent temp and manifold air temp sensor (we have one right?)

------------------
- David
88' GTA 5.7L TPI MODS---> air foil, K&N, Shift Kit, 180* therm, TB bypass, Gutted CAT, Flowmaster 80 Series

http://www.geocities.com/david_angel_16
Old 10-19-2001, 06:59 AM
  #4  
Supreme Member

iTrader: (10)
 
MikeH's Avatar
 
Join Date: Jul 1999
Location: Fla
Posts: 1,780
Likes: 0
Received 2 Likes on 2 Posts
Car: 90 IROC
Engine: 406
Transmission: GMPP 93/4L60
Axle/Gears: 9 bolt 3.27
Is the motor turning over but not starting? Or is it not turning over at all? Or turning slowly when its hot?

------------------
90 IROC
SuperRamed 406
Trickflow 23* heads
Old 10-19-2001, 10:54 AM
  #5  
Junior Member
Thread Starter
 
silver89Rs's Avatar
 
Join Date: Jul 2001
Location: westland mi
Posts: 82
Likes: 0
Received 0 Likes on 0 Posts
it doesnt turn over at all. but if i wait a while it starts right up
Old 10-19-2001, 12:12 PM
  #6  
Moderator

 
IROCThe5.7L's Avatar
 
Join Date: Jul 2001
Location: Buffalo, NY
Posts: 5,193
Received 58 Likes on 39 Posts
Car: 1988 IROC-Z
Engine: 427 SBC
Transmission: ProBuilt 700R4
Axle/Gears: Moser 12 Bolt / 3.73 TrueTrac
With mine it turns over fast whether its h ot or cold. Just starts 6 times better when Cold.

------------------
1988 Jet Black IROC
5.7L W/ 64000 miles
Flowmaster Exhaust
Fully Loaded
------------------

My IROC In Readers Rides
My IROC
Old 10-19-2001, 05:12 PM
  #7  
Supreme Member

iTrader: (9)
 
1MeanZ's Avatar
 
Join Date: Sep 2001
Location: North Central Indiana
Posts: 2,984
Received 36 Likes on 28 Posts
Car: 86 IROC
Engine: 383
Transmission: TKO 600
Axle/Gears: 3.54 Dana 44 IRS
if it turns over slow when hot your starter is could be getting heat soaked, therefore making it get weak. check to make sure your battery cables are good and clean. make sure you have a good strong ground. also when an engine is really not things expand and clearances are tighter in the engine, and on a warm engine there is oil on the rings causing compression to be a little higher.

if it cranks over but wont start when hot, check to see if your fuel mixture is off. lean or rich, and retard your timing a bit.

------------------
86 IROC
43,000 miles
305/700R4/3.23 gears
maroon, gold stickers, black interior, T-Tops.

current mods.
shift kit
headers
cat back exhaust

mods planned for this winter
cam
3.73 gears
subframe connecters

[This message has been edited by 1MeanZ (edited October 19, 2001).]
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
03-05-2017 06:37 PM
Orr89RocZ
Power Adders
206
04-25-2016 08:28 AM
TheExaminer
Cooling
26
08-26-2015 04:59 PM
86Base
TPI
14
08-08-2015 01:34 PM



Quick Reply: hot start



All times are GMT -5. The time now is 06:40 PM.