gt auto

I just removed all my smog stuff and installed new injectors at the same time. I took all the vacuum hoses off and thought I would replace them all. I took some pictures of them before I took them off but messed up when I was putting them on my pc. Anyone have some good diagrams or pictures.
Thanks,
GT Auto

8Mike9

May catch a response if you let folks know what kind of car/yr/etc, you have.

deadbird

I replied to you asking that over in the TPI forum but I suppose you didn't see it..

https://www.thirdgen.org/messgboard/...ML/005562.html

That's the only diagram I have, it's from the emissions label off an '89 or so TPI camaro, I'd be almost willing to bet just about all TPI's are the same for emissions vac. routing.

------------------[*]my Formula Homepage [*]Collision P/Ns & Diagrams

"Always do sober what you said you'd do drunk. That will teach
you to keep your mouth shut."

gt auto

That would work. it is a 88 305 tpi motor. What I need is the hoses frome the plenum and the fule pressure reg. and the I guess check valve thing.

deadbird

The hose on the drivers side of the back of the plenum go to the brake booster

The far back line (I think) on the pass side goeas to the cruise control

The forward vac. port of the one mentioned above, towards the nose, on the pass side, back of the plenum, goes to the FP reg.

The cruise is the larger of the 2 on the pass side rear of the plenum.

------------------[*]my Formula Homepage [*]Collision P/Ns & Diagrams

"Always do sober what you said you'd do drunk. That will teach
you to keep your mouth shut."