Where to tie AFPR Vacuum line into Miniram Intake???
01-06-2006, 04:21 PM
#1
Member
Thread Starter
iTrader: (2)
Join Date: Sep 1999
Location: Palos Hills, IL USA
Posts: 351
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 25th Anniversary Z28
Engine: 6.3L - 383
Transmission: 700R4; Vig 3200
Where to tie AFPR Vacuum line into Miniram Intake???
Since the MR only has the 4 vac. inlets, I'm unsure where to tie the AFPR line into. On the drivers side, I have the brake booster in one and the PCV into the other, on the pass. side I have the MAP sensor in one and the heater/vent line in the other....I think that one has a valve tied into it as well. What's the best way to tie the AFPR line in??? Is it as simple and throwing a small Tee into the heater/vent line? Would that be best?
Thanks
- Joel
Thanks
- Joel
01-06-2006, 07:41 PM
#2
Supreme Member
iTrader: (1)
Join Date: Sep 2005
Posts: 26,160
Received 1,697 Likes
on
1,290 Posts
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Tee it off the same place as the MAP; since there is essentially no "flow" in that line. That would be better than sharing the HVAC one. Make sure both pieces of line are as short as possible, and preferably made out of the hard plastic tubing rather than rubber.
Thread
Thread Starter
Forum
Replies
Last Post
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
20
11-14-2015 12:02 AM
mdtoren
Tech / General Engine
0
08-16-2015 05:45 PM
