350 TPI w/ 4 speed ???
05-05-2006, 08:33 AM
#1
Member
Thread Starter
Join Date: Jul 2005
Location: Jacksonville, Florida
Posts: 460
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro Z28
Engine: 5.7 LT1
Transmission: 4L60
Axle/Gears: 3.23's
350 TPI w/ 4 speed ???
After I pulled out my 350 TPI for my LT1 swap, me and my buddy are deciding to put the leftover TPI in our 2.8 87 Camaro beater. I have all of the wiring, harness etc. The 87' has the 2.8v6 with a 4 speed standard. Will the TPI bolt up to this ? and if it does how long will the 4 speed last under the torque of the TPI ??
05-05-2006, 09:23 AM
#2
Supreme Member
Join Date: Jul 2005
Location: North Central Mass.
Posts: 2,123
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Berlinetta
Engine: Megasquirted TPI
Transmission: Transgo 700R4
Axle/Gears: 3.42
no. The v6 is a 60 degree motor and the v8 a 90 degree motor. The transmissions will not work.
05-06-2006, 01:29 AM
#3
Supreme Member
iTrader: (1)
Join Date: Jul 2004
Location: Calgary, AB, Canada
Posts: 10,763
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
you could use the trans that was mounted to that 350 TPI motor right? since you're using the new T56 that came with the LT1?
05-06-2006, 12:25 PM
#4
Member
Thread Starter
Join Date: Jul 2005
Location: Jacksonville, Florida
Posts: 460
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro Z28
Engine: 5.7 LT1
Transmission: 4L60
Axle/Gears: 3.23's
Ya I guess were gonna do that, we wanted to use the 4 speed but since it wont bolt up right, were gonna use the 700r4.
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
05-17-2020 10:44 AM
Hotrodboba400
Firebirds for Sale
3
12-10-2019 07:07 PM
