Camshaft Retainer
09-06-2007, 07:56 PM
#1
Member
Thread Starter
Join Date: Jun 2005
Location: Tucson, AZ
Posts: 217
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 GTA
Engine: L98 350
Transmission: Swapped to a T-5
Axle/Gears: 3.27
Camshaft Retainer
So I was tightening up the Retainer bolts and one snapped on me! I didn’t think I did it too tight but they are small... Anyways I need a new bolt and I don’t know where to get it. I looked at Jegs and Summit for the bolts and they don’t have them. However Jegs does sell the retainer but it wont say if it comes with the bolts. So I went to GM Parts Direct and found out they have 2 types of these retainers. Here is the description of part #10088128 off GM Parts Direct
I'm guessing and hoping its part #10088128 if I’m wrong please correct me. Now to my question has anyone ever bought this and does it come with the bolts? Or is there a place anyone knows of where I can buy the bolts?
"1st design 10088128 (3.62" bolt center) used on ZZZ-1-2
And 10168501 2nd design (3.294" bolt center) used on ZZ3 and ZZ4 350 engines"
And 10168501 2nd design (3.294" bolt center) used on ZZ3 and ZZ4 350 engines"
09-06-2007, 08:27 PM
#2
Senior Member
iTrader: (2)
Join Date: May 2003
Location: Huntsville, AL
Posts: 539
Likes: 0
Received 2 Likes
on
2 Posts
Car: 87 GTA, 88 GTA, 92 TA, 72 RS SS
Engine: 350, 350, 305, 396
Transmission: T56, 700r4, 700r4, T56
Axle/Gears: 3.42, 3.23, 3.23, 3.73
Re: Camshaft Retainer
Why don't you go to a hardware store and find the replacement? Its not a special bolt, just match the grade, length, thread pitch and most importanly make sure the head of the bolt is atleast the same thickness or thinner than the original.
Thread
Thread Starter
Forum
Replies
Last Post
