Smoke the camaro...
#1
Member
Thread Starter
Join Date: Sep 2007
Location: Alexandria, VA
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Iroc-z28
Engine: 5.7 350
Transmission: 700R4
Axle/Gears: 2.77
Smoke the camaro...
88 iroc z28 5.7 350 smokes like no ones business. Smokes a lot when started up then doesn't smoke until reved. video enclosed http://www.youtube.com/watch?v=Gp6darkgCvA
Valve stem seals?
Thanks
Valve stem seals?
Thanks
#2
Senior Member
iTrader: (1)
Join Date: Jul 2007
Location: MA
Posts: 1,141
Likes: 0
Received 2 Likes
on
2 Posts
Car: '87 IROC/'68 SS
Engine: 5.7L/350
Transmission: 700R4/Muncie 4-spd
Axle/Gears: 3.27 9 bolt / 3.31 12 bolt
Re: Smoke the camaro...
88 iroc z28 5.7 350 smokes like no ones business. Smokes a lot when started up then doesn't smoke until reved. video enclosed http://www.youtube.com/watch?v=Gp6darkgCvA
Valve stem seals?
Thanks
Valve stem seals?
Thanks
#3
Member
iTrader: (1)
Join Date: Apr 2007
Location: Sioux Falls, SD
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 Firebird
Engine: SBC 383/88BW
Transmission: Built 700R4
Axle/Gears: Moser 9in/3.55
Re: Smoke the camaro...
Rings? changed the oil lately? check out your crank ventilation system maybe its just not sealing... happened on mine
#4
Member
Thread Starter
Join Date: Sep 2007
Location: Alexandria, VA
Posts: 229
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1988 Iroc-z28
Engine: 5.7 350
Transmission: 700R4
Axle/Gears: 2.77
Re: Smoke the camaro...
----------
OH BY THE WAY: MY CAT IS BURNT UP. so I'm just putting that out there.
Last edited by Avernus; 11-06-2007 at 09:48 PM. Reason: Automerged Doublepost
#5
Member
iTrader: (1)
Join Date: Apr 2007
Location: Sioux Falls, SD
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
Car: 85 Firebird
Engine: SBC 383/88BW
Transmission: Built 700R4
Axle/Gears: Moser 9in/3.55
Re: Smoke the camaro...
i was sayin crankcase vent, only because after i replaced the crankcase vent, it stopped smoking (it smoked just a little bit before) I seen a post somewhere... and since the crankcase now had a good suction it helped keep the rings tighter to the cylinder not sure how it works
a cp test would help, HOPEFULLY its only one piston
a cp test would help, HOPEFULLY its only one piston
Thread
Thread Starter
Forum
Replies
Last Post