Serpentine Pics needed
#1
Member
Thread Starter
iTrader: (2)
Join Date: Jul 2005
Location: Bloomingdale, NJ
Posts: 459
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Z28
Engine: 350
Transmission: T-5 5 Spd
Axle/Gears: Built 10bolt w/3.73s
Serpentine Pics needed
I have a B&M supercharger I want to install in my car and at the same time I want to swap to serpentine, so I pulled a setup out of a '91 Jimmy. I also want to run this all off of one belt similar to this guy:
https://www.thirdgen.org/forums/powe...erpentine.html
Only I want to use the A/C and factory tensioner as opposed to the chinsy one the blower came with. Now looking at the pic of a 3rd gen serp setup the tensioner looked like it was over far enough. I mocked up a topend with the Jimmy setup definetly not going to work like I imagined it. The tensioner is in the way of where the snout goes. Can anyone take some shots of their serp setup, so I can decide if a 3rdgen bracket would work for me?
https://www.thirdgen.org/forums/powe...erpentine.html
Only I want to use the A/C and factory tensioner as opposed to the chinsy one the blower came with. Now looking at the pic of a 3rd gen serp setup the tensioner looked like it was over far enough. I mocked up a topend with the Jimmy setup definetly not going to work like I imagined it. The tensioner is in the way of where the snout goes. Can anyone take some shots of their serp setup, so I can decide if a 3rdgen bracket would work for me?
Thread
Thread Starter
Forum
Replies
Last Post