Temperature Gauge + Water Pump
02-09-2008, 10:51 AM
#1
Senior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2007
Location: Glen Mills, PA
Posts: 280
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Chevrolet Camaro RS
Engine: 305 T.B.I.
Transmission: 700R4
Axle/Gears: 2.73 Open Diff
Temperature Gauge + Water Pump
I tried installing an aftermarket sunpro temperature gauge yesterday. I used teflon and everything and the water pump started leaking. Any suggestions? I have the correct sized fitting
02-09-2008, 02:14 PM
#3
Junior Member
Join Date: Nov 2007
Location: Michigan
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Car: 84 Z28
Engine: 383
Transmission: 700r4
Axle/Gears: 7.5 3.73
Re: Temperature Gauge + Water Pump
I had the same problem, I ended up stripping the adapter, so i used the other adapter and put it in the head. or go to a hardware store and get a stronger adapter. The brass is to weak.
02-09-2008, 02:36 PM
#4
Senior Member
Thread Starter
iTrader: (1)
Join Date: Oct 2007
Location: Glen Mills, PA
Posts: 280
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Chevrolet Camaro RS
Engine: 305 T.B.I.
Transmission: 700R4
Axle/Gears: 2.73 Open Diff
Re: Temperature Gauge + Water Pump
My adapter is not stripped and I think it's leaking out of the fitting that goes into the water pump because there are 2 fittings one that goes into the other fitting and the one that goes into the pump itself. I tried like 3 different times and just finally gave up and put the original plug back in
02-09-2008, 05:08 PM
#5
Member
Join Date: Jan 2007
Location: eastern mass
Posts: 385
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 firebird none soon
Engine: None
Transmission: none
Axle/Gears: 2.73 10 bolt
Re: Temperature Gauge + Water Pump
find the thread lok for pipe fittings i have never heard of it leaking and they have it at the home depot
Thread
Thread Starter
Forum
Replies
Last Post
evilstuie
Tech / General Engine
22
01-09-2020 08:29 PM
