Need some Torque Specs
#1
Need some Torque Specs
I will be putting my motor back together either tonight or tomorrow and need some torque specs. I don't have a manual and don't feel like spending $19.99 on a chiltons at schucks. Unless it is really worth it? Anyways I need head bolt specs, water pump, and Rocker arm nuts with stock heads.
Thank you.
Thank you.
#4
Supreme Member
iTrader: (1)
Join Date: Jul 2004
Location: Calgary, AB, Canada
Posts: 10,763
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
Re: Need some Torque Specs
rocker arm nuts? this is a hydraulic cam, you do it to lash.
water pump uses 3/8NC bolts, call it 35ftlbs or so.
that's about "tight".
water pump uses 3/8NC bolts, call it 35ftlbs or so.
that's about "tight".
#6
Re: Need some Torque Specs
Thanks. I guess I will just go buy it then probably be really usefully. Thank you for the replys so quickly.
The studs are installed into the cylinder head then the rocker arm goes over the stud then theres a bearing sort of thing that goes inside the rocker arm then a nut goes over it to hold the rocker arm in place over the Valve spring. It's all stock I guess.
The studs are installed into the cylinder head then the rocker arm goes over the stud then theres a bearing sort of thing that goes inside the rocker arm then a nut goes over it to hold the rocker arm in place over the Valve spring. It's all stock I guess.
Thread
Thread Starter
Forum
Replies
Last Post
no green
Engine/Drivetrain/Suspension Parts for Sale
11
01-09-2016 09:22 PM