what does code 36 mean?
#1
Junior Member
Thread Starter
Join Date: Sep 2009
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Car: 89 IROC-Z camaro
Engine: 350 5.7 TPI
what does code 36 mean?
Ive got a 1989 Camaro IROC-Z, and i went to start it yesterday and my SES ( service engine soon) light came on...so i used the paper clip trick and i got a code 36...what does it mean..and is it an easy fix..is it safe to drive with a code 36?
#4
Member
Join Date: Dec 2007
Location: NYC
Posts: 149
Likes: 0
Received 1 Like
on
1 Post
Car: 1988 gta-
Engine: 383 tpi
Transmission: 700 r-4
Re: what does code 36 mean?
I got the same code and it was an easy fix, if you look by the firewall behind the master cylinder there is a set off relays one being particularly rectangular ,that one is the MAF power relay i changed that one and the other one all the way to the right is the burn off relay i changed that one and so far the light hasn't come back on. Hope this helps each relay is about 12 bucks at auto zone one of the part numbers is MR22. Good Luck.
#5
Supreme Member
Join Date: Mar 2008
Location: CT
Posts: 1,549
Likes: 0
Received 1 Like
on
1 Post
Car: 86 T/A, 83 Z/28
Engine: 5.0 TPI, 350 2 X 4 bbl
Transmission: 4 speed auto, 5 speed manual
Axle/Gears: 3.23 posi, 3.73 std
Re: what does code 36 mean?
What a code 36 is is a burn off system failure. What the burn off system is, is a system that basically pulses 12V to the MAF after you shut the car off to burn off any crap from the MAFs sensing wire. This keeps it clean and prevents it from reading inaccurate (these sensors are and have to be very accurate thats why there so expensive) due to build up on the wire. So ide deffinetly run through the procedure to troubleshoot it although its not a critical failure running that makes the car undriveable the car like that will eventually damage the MAF because its not being cleaned. Should be an easy fix most likely.
#6
Junior Member
Join Date: May 2018
Location: Oklahoma
Posts: 30
Received 0 Likes
on
0 Posts
Car: 1988 IROC-Z
Engine: 350 TPI
Transmission: 700-R4
Axle/Gears: 2.77 Positrac
Re: what does code 36 mean?
Yeah hi guys.
I needs an update in this thread pliz.
Did the relay fix it?
I needs an update in this thread pliz.
Did the relay fix it?
Thread
Thread Starter
Forum
Replies
Last Post